cat
Assuming you are attempting to puncture a balloon and keep it intact, I would reccomend puncturing the balloon near the knot, where the rubber is thick and not streched out. If you are trying to pop the balloon, then I would puncture the balloon where the rubber is thinnest.
a dog The more massive an object is, the greater its inertia.
The balloon may lose some air during that half hour.Also, at a lower temperature, the remaining air uses less space.
The answers depend on the sizes of these objects.
Think about this one and it will become crystal clear. The more mass an object has, the more inertia it has. It's that simple. Inertia is the property of a body that it resists a change in motion. If it's moving, it wants to keep going. If it's sitting still, it doesn't want to move. Inertia is resistance to any change in velocity. And the larger a mass is, the more resistant it is to a change in velocity. There is a direct correlation between the mass of an object and its inertia. A school bus rolling down the road has more inertia than that superbike that is rolling along side of it. And by a long shot. A link can be found below. At least read the first couple of paragraphs of the post. It will be worth the trip over to Wikipedia, where our friends there post knowledge for free.
When a balloon is released, the air inside moves backward due to inertia, propelling the balloon forward in the opposite direction. The inertia of the moving air creates a force that pushes against the balloon, causing it to move in the direction of least resistance.
your mama!! HAHA!!
Bowling
at least 6
No, the balloon with the least amount of air will not necessarily go out faster. Factors such as wind speed and direction, temperature, and weight of the balloon will also affect the rate at which the balloon goes out.
a golf ball is heavier
Ballon means either 'balloon' (a hot-air balloon) or 'ball' (at least the size of the handball one).
balloon pop
the one that weighs the least do ur study island
for 10 pin, 12
If one were to sculpt a solid weight bowling ball from the suggested paper mache, it is likely to take at least 5 cups of water for a 5-pin bowling ball and at least 16 cups of flour for a 10-pin bowling ball. Consider in order to solidify the mache mixture, that each of these measurements will need to mix at least twice as much water, over the flour.
For at least six hours before balloon valvuloplasty, the patient will have to avoid eating or drinking anything