No, connecting an L5-30P (30A, 125V) to an L14-30R (30A, 250V) will not provide 120V. The L14-30R is designed for 240V applications, and if connected, it would not properly supply voltage to the L5-30P as intended. Additionally, using these connectors together may pose safety risks and is not recommended. Always ensure compatibility and adhere to electrical codes when making connections.
The correct wiring diagram for a 120v line voltage thermostat installation typically involves connecting the line and load wires to the appropriate terminals on the thermostat. It is important to follow the manufacturer's instructions and consult a professional if needed to ensure proper installation and safety.
the simplest solution is by connecting two 120v 3amps heater in series , the same can be used directly on 240v. However the current drawn will still be 3 amps & Not 1.5 amps. The heater output power will be double that of a single heater running on 120v. ( or equvalent to two heaters operating on 120v. supply ) A more expensive method is to use a stepdown transformer which can be powered on 240v & connect the heater on the transformer 120v side. this method will consume approx. 1.5 amps from the 240v supply.
To wire a 120V A base emitter for 120V, you would typically connect the emitter to the ground, the base to the input voltage source (120V), and the collector to the load. Ensure you follow proper safety precautions and consult the specific datasheet for the A base emitter you are using for correct wiring instructions.
No, a 120V light bulb should not be used in a 250V socket. The bulb is designed to operate at a lower voltage, and connecting it to a higher voltage source can lead to overheating, damage, and potentially cause the bulb to burn out or even create a fire hazard. Always use bulbs that match the voltage rating of the socket to ensure safety and proper functioning.
120v
To calculate watts, you can use the formula: Watts = Volts × Amps. For a 120V, 60Hz, 12A circuit, it would be: 120V × 12A = 1,440 watts. Therefore, the circuit uses 1,440 watts.
You can energise the circuit by connecting to a neighbour's supply, then they will pay for the energy used. Anything different is classed as theft. An electrician would be needed to do the job safely.
You can find a 120V power cable at your local hardware store. Look in the section under extension cords.
No.
It is 120V/60Hz
no 208v is bigger
12