There could be several reasons why the brakes won't release on your car. It could be due to a problem with the brake calipers, brake pads, brake fluid, or the brake system itself. It is important to have a professional mechanic inspect and diagnose the issue to ensure safe and proper functioning of your brakes.
No.
A repair shop can release a car with bad brakes if they were not asked to repair the brakes or the customer refused service. It is then the responsibility of the customer to have them repaired.
you can tell when your breaks start to Squeak or the car wont slow down when turning
my Acura legend brakes are fine and Thank you the problem is my interior inside my car looks like dirty and i need to clean it so it will look brand new... I love my 1992 Acura Legend.
I have a 99 grand am and I am tring to replace the brakes on the front of my car but when I go to put the brakes back on the caliper wont line up wheats wrong with this? How do I fix this?
Assuming you are not pressing down on the gas, when you release the pedal, the car will slow down over time and evetualy come to a stop. Unless you are going down a hill, in which case you will speed up.
Hydraulic brake assist- means the car wont roll back on a hill start, without the handbrake or brakes being operated, even with the clutch depressed
There are front brakes and rear brakes. There are a total of four brakes on a car. Every wheel on the car has its own brake and every car has the same number of brakes.
Yes, I understand the emergency brake has to be off so the pads wont be up against the disc or drum when attempting to change the brakes and rotors.
If the brakes are out then you have no business putting it in any gear because it is unsafe to drive a car with no brakes.
the brakes use friction to stop the car
RELEASE THE ACCELERATOR FIRST, then turn...do not apply the brakes this is because the ability for your car 2 steer is dependant on the friction between the road and tyres. if u apply the brakes u risk at locking them up. if this happens there is nearly no friction and u wont b able 2 make the turn. what u want to do is to use as much of that friction solely 2 turn the car...hence u should not use the brakes