The gas line valve is currently off.
The gas shut off valve is currently in the off position.
The gas valve is currently in the off position.
The 90-degree gas valve is currently in the off position.
Install in gas line to shut off gas to building after gas meter, or to isolate an appliance off a gas line.
To determine if a gas line is turned on or off, locate the gas meter and check the position of the valve. If the valve is parallel to the gas pipe, it is open (on). If it is perpendicular, it is closed (off). Be cautious and consider seeking professional help if unsure.
The main gas shut off valve in a typical household is usually located near the gas meter, where the gas line enters the house.
gas valve handle if it is long, turned with the length of the hande in line with the pipe is the ON position. with the length of the handle at a 90 Degree angle to the gas line is in the off position. NORMALY. If you intend on opening up your gas line. Don't do it. Get a pro.
To change the gas valve on a water heater, first turn off the gas supply and water supply to the heater. Disconnect the gas line and remove the old gas valve. Install the new gas valve and reconnect the gas line. Finally, turn the gas and water supplies back on and test the water heater to ensure it is working properly.
To change the gas valve on a water heater, first turn off the gas supply and water heater. Disconnect the gas line and pilot tube from the old valve. Remove the old valve and install the new one in its place. Reconnect the gas line and pilot tube, then turn the gas supply and water heater back on.
The gas valve is off in the current situation.
The status of the washing machine water valve is currently off.
I assume there is not a shut off on the supply side of the line. If you are used to working with gas, you can do it with the line charged, but it is probably best to shut the gas off at the main. If there is not a shut off valve where the flex line connects, I would put one there now. Then it is just a matter of changing the line. Do not use any pipe dope or tape on a gas connection, at least on the flex line. This is a flare fitting and does not require it. The valve to pipe connection is a plumbing connection and should have dope or tape on the threads.