0
What else can I help you with?
What is pulley puller?
an electric tool
How do you replace front wheel bearing peugeot boxer do you need a bearing puller?
Get a manual for this vehicle.
What do you mean with appl. in Radiator Appl?
Am not sure if this is it. http://www.amazon.com/Flex-lite-280-Electric-Puller/dp/B000CNHFTE
What kind of electric fan sits behind the radiator on the drivers side?
Its mostly likely a puller fan to cool the transmission of your car
How do you remove a pulley from an electric motor?
To remove the pulley from an electric motor, you typically need to use a pulley puller tool. This tool grips the pulley securely and allows you to apply force to pull it off the motor shaft without causing damage. Follow the manufacturer's instructions for using the pulley puller properly to safely remove the pulley.
What size are the puller bolt holes on a 3.3 balancer?
The puller bolt holes on a 3.3 balancer typically measure 8mm in diameter. It's important to use the correct size and thread pitch for the puller bolts to ensure proper fit and functionality during the removal process. Always consult the specific service manual for your vehicle for any variations or specific requirements.
How to remove the harmonic balancer on a 1999 5.7 vortec?
You need a socket to fit the holding nut and a large gear puller. Instructions are in the manual for the vehicle.
When was Lifter Puller created?
Lifter Puller was created in 1994.
When did Lifter Puller end?
Lifter Puller ended in 2000.
How do you remove a harmonic balancer?
Depends on the engine make, but you almost always need a large 3-jaw gear puller. Look at your engine manual for specific instructions.
How do you change the power steering pump on a 2000 Malibu?
Your best bet is to buy a Haynes Manual that is for your car. While you are at it you will need a power steering pulley puller and installer.
Do I need a special puller to pull the crankshaft sprocket on a 93 Dodge shadowFAQ754-2?
Yes, you will typically need a special puller to remove the crankshaft sprocket on a 1993 Dodge Shadow. This tool is designed to apply even pressure and prevent damage to the sprocket or the crankshaft during removal. Using the appropriate puller ensures that the job is done safely and efficiently. Always consult your service manual for specific instructions and recommendations.
