0
What else can I help you with?
How are lower voltages combined into higher voltages for transmission?
Low voltages are not 'combined into higher voltages' for transmission! The lower voltage (e.g. the voltage generated at a power station) is applied to the primary winding of a large power transformer, and the required higher transmission voltage then appears across the transformer's secondary winding. The magnitude of the secondary voltage is determined by the turns ratio of the transformer's windings.
How do i convert from 380 volts to 220 volts?
If these are the exact voltages that you need you will need an auto transformer to obtain these voltages. If these voltages are nominal voltages and are of a three phase four wire configuration, the 220 voltage can be obtained from the three phase legs to the neutral (ground) connection. The equation to use is 400/1.73 = 231 volts.
What is uses of tapped coil?
If question is about a transformer's tapped coil then the taps are a way of getting different voltages from one transformer. The end of the transformer's coil is the common point and the taps to this common point will give different voltages depending on where in the coil the taps are taken from.
How efficient is a transformer when changing voltages?
A: Must understand this A transformer transfer power minus efficiency to another level that all it does.
Is 3 phase star transformer has more winding than delta?
The # of windings in a transformer are based on the primary and secondary voltages the transformer is rated for not the way the windings are connected.
Uses of transformer?
transformers are used to step up or step down the voltages
Is a device that changes the voltage of an alternating current with little loss of energy?
The device you are referring to is called a transformer. Not only can a transformer increase voltage, it can decrease voltage as well. These are known as a step up transformer for increasing voltages and step down for decreasing voltages.
What is phase shift in three phase transformer?
The phase shift in three-phase transformer from winding of Transformer and determine by vectorgroup of transformer such as YNd1 High voltage connect to wye Low Voltage connect to delta so L.V. lag H.V 30 degree.Answer'Phase shift' or, more accurately, 'angular displacement', is the angle between the secondary line voltages and primary line voltages of a three-phase transformer.
Why are using transformer in circuits?
Transformers are use in circuits to step up and down voltages.
Can you use transformer with your 110 aircon?
A transformer can be used to change the voltage to an appliance. The voltage rating of the transformer should be right for the voltages used, and the current rating of the transformer should not be less than the current drawn by the equipment.
What is approximate turns ratio of the centre-tapped transformer used?
It depends on the voltage ratio of the transformer. If you know the primary and secondary voltages, then you can work it out for yourself.
Does the formula used to calculate the turns ratio uses the phase voltages and phase current?
For a transformer, the turns ratio always applies between its primary and secondary windings. So the turns ratio for a three-phase transformer is the ratio of primary to secondary phase voltages, not between line voltages.
