Yes, in most states, you are required to surrender your license plate when you no longer need it, such as when you sell your vehicle or cancel your registration. This helps prevent misuse of the plate and ensures proper documentation of vehicle ownership.
You need to remove the liner on the trunk lid. That will give you access to the license plate lights housing. Remove the sockets by twisting 1/4 turn and replace bulbs. Size for bulbs are 2825
To remove the license plate screws from a Nissan Murano, you typically need a flathead or Phillips screwdriver, depending on the screw type. Start by locating the screws holding the license plate in place, then use the screwdriver to turn them counterclockwise until they are completely removed. Once the screws are out, carefully take off the license plate from the bracket. If the screws are rusted or stuck, applying a penetrating oil may help loosen them.
The following Instructions are for all 1991, 92, 93 DeVille Sedans and Coupes.Remove rear license plate.Remove 4 nuts underneath license plate.Separate license pocket (with reverse lights) from body.Remove license plate lamp socket from license plate pocket (1/4 turn counter clockwise)Pull bulb (straight out) from socket.Push new bulb into socket (line up blade to slot in socket).Install license plate lamp socket to license plate pocket (1/4 turn clockwise)Install license pocket (with reverse lights) on to body.Install 4 nuts underneath license plate.Install rear license plate.
push up and turn on the housing
As a GENERAL rule plate covers are legal as long as they do not change the colors of the license plate or obscure the letters/numbers or state of issue in any way.(note: due to the discoloring action of the sun on plastics, some so-called 'clear' plastics tend to turn yellow pretty quickly - once that occurs they are no longer 'clear.')
Look above the license plate and find the bulb assembly, grasp the flat part turn it clockwise and pull it out, the bulb just pulls straight out.
how to change the license plate bulb onLook at the rear plate , then get on the ground so you can look up to the underside of the bumper, where the plate is. There are two Phillips screws the hold your plate light, remove both, pull down gently on the light, then turn it co you can see the rear and with both Hans turn the socket and pull, there you will find the bulb. change it and do the reverse to install.
To change that bulb push the bulb down and turn to take out you may need to unscrew the cover first and replace it with the same bulb
well depend what kind of scooter is for example super bike are street legal in some states if they have turn signal, insurance, and license plate.
There should be a connector for the lights above the rear bumper, but you may not want to disconnect it because then your likely to get pulled over for having a faulty license plate light
unbolt lens, remove bulb socket quarter turn
You can turn it in to your local Police or Sheriff's office. They will handle it from there.