I've only seen this question posed in the form of a crossword puzzle clue. In this case it is refering to the torso of ones body. The torso is the trunk of your body.
remove rear seat and insulation
how do i replace a trunk lock with another lock that has a key
pick the lock or use a skeleton key
press the door lock open or lock for 5 seconds.
I have an buick regal custom 1992 and in my glove box there is a trunk release button. yellow. Not sure if this is a standard
To replace the trunk lock on a 1996 Nissan Maxima, start by removing the trunk lining to access the lock mechanism. Disconnect the wiring harness and unscrew the lock assembly from the trunk lid. Replace it with the new lock, reattach the wiring harness, and secure it with screws. Finally, replace the trunk lining to complete the installation.
Yes, you can lock a 1996 Ford Crown Victoria's trunk from inside the car by using the trunk release mechanism. If the trunk release lever is functional, pulling it will unlock the trunk, and then you can manually lock it using the key or the trunk lock itself. Additionally, ensure that the trunk's latch is functioning properly to keep it secured. However, there is no electronic way to lock the trunk from the inside; it must be done manually.
Look under the trunk's lid.
On my 1992 190E I can lock the trunk with any of the keyed locks. If you lock the doors, the trunk locks and if you lock the trunk, the doors lock. In other words all the keyed locks are electrically interconnected. In reality the locks are not electrically interconnected. There is a pump in the right side wheel well of the trunk, it uses vacuum to lock all the locks and pressure to unlock them. Although the pump is powered electrically, the locks are not.
To install a trunk lock on a 1991 Buick Park Avenue, first, remove the trunk lining to access the lock assembly. Disconnect the electrical connector if the lock has a keyless entry feature, then unscrew the old lock from its mounting bracket. Install the new trunk lock by securing it in place with screws, reconnect the electrical connector if applicable, and replace the trunk lining. Finally, test the lock to ensure it operates smoothly.
To replace the trunk lock on a 2000 Dodge Neon, first, remove the trim panel inside the trunk to access the lock mechanism. Disconnect the electrical connector and any rods attached to the lock. Unscrew the lock assembly from the trunk lid, then replace it with the new lock and reassemble the components in reverse order. Finally, test the new lock to ensure it functions properly.
* Remove the trunk lid latch * Detach the lock release box from the latch assembly * To detach the lock cylinder from the trunk lid pry off the retainer