answersLogoWhite

0

If it's a fluid filled hub, yes.

User Avatar

Wiki User

9y ago

What else can I help you with?

Related Questions

Your Chevy Cavalier is leaking power steering fluid you noticed a whiney sound when you turned the wheel and a puddle of fluid under the car. I added fluid but it keeps happeneing?

You need to find the leak and fix it. Can be a hose clamp, can be a seal on the servo pump.


Why is there fluid leaking from your drum brake?

IF you have rear wheel drive it may be a grease seal for the rear differential. Otherwise it is probably a wheel cylinder. Check your brake fluid level. GEt this fixed ASAP- Safety concern. Wheel cylinder, brake fluid.. If it's a rear wheel drive vehicle, it may be the axle seal leaking as well. Hello... hello...


What is the fluid leaking from rear passenger wheel on a jeep wrangler?

Probably brake fluid, your caliper seal may have gone bad


How can you tell if a rear wheel seal is leaking?

You'll see either fluid or grease leaking out of it.


Why would brake fluid be leaking from behind the front wheel on a 1996 land rover discovery?

Hub seal is leaking


How do you change axle seal on a 2002 hyundia elantra?

You have to pull the entire axle. Take off the tire and wheel hub. unbolt the tie rod from the wheel hub. unbolt strut assembly from wheel hub. Pull transaxle drain plug to empty as much fluid as possible. Use a pry bar to remove the right side drive shaft from the transaxle. Note that some fluid will still leak, despite having drained the transaxle. use a screwdriver to remove the old seal. Moisten new seal with fresh transaxle fluid prior to installing. Install new seal with a seal installer tool and mallet, by gently tapping it into place. Reinstall axle by following steps in reverse order. Don't forget to replenish transaxle fluid with SPIII fluid!


What seal needs replacing if transmission is leaking fluid?

Whatever seal the fluid is coming out.


How do you replace a rear wheel bearing and seal on a 98 Toyota Tercel?

how do i replace a wheel seal


What is the purpose of the bottom door seal strip and how does it help in maintaining the integrity of the door?

The purpose of the bottom door seal strip is to prevent air, water, and debris from entering or escaping through the bottom of the door. It helps maintain the integrity of the door by creating a tight seal that keeps the interior of the door protected from external elements, such as drafts, moisture, and dirt.


What is a wheel bearing seal on a truck?

Okay.... so you have a spindle which is attached to the axle... this is what the wheel actually mounts on. Within that spindle are several components, of which the most important to note are the two bearings (and corresponding races). Now, bearings roll, and thus, they need to be lubricated. This is done with gear oil. The wheel seal at the back of the bearing keeps the gear oil in the spindle.


Where are the magnets in refrigerator located?

The magnets in a refrigerator are typically located along the edges of the refrigerator door. They are embedded within the rubber gasket that creates a seal when the door is closed, ensuring the refrigerator maintains its internal temperature. This magnetic seal helps prevent cold air from escaping and keeps the refrigerator efficient.


Your steering wheel turns itself the power steerin fluid is full you cant turn your wheel when you stop your wheel turns itself in multiple circles what is wrong?

Internal seal in the Rack & Pinion steering. You probably shouldn't drive it until you get it fixed.