Yes, the JOHN DEERe 214 is a very reliable tractor. Visit www.compacttractorreview.com and http://www.consumersearch.com/lawn-tractors/reviews to read reviews of the tractor.
Here the list of tractors 214 for sale -http://for-sale.yakaz.com/john-deere-214-for-sale-
www.craigslist.com should have listings for tractors in your area; additionally, Home Depot and Lowes sells tractors.
I have one that is a 175 Hydro and it uses an AM101054 which is very common for Kawasaki engines. I got one at the local lawn equipment shop for $10.
To change the mower deck on a John Deere 214, first, ensure the mower is turned off and the key is removed. Raise the deck to its highest position and disconnect the drive belt by removing the belt from the pulley. Next, detach the deck by removing the pins or bolts that secure it to the tractor and carefully lower it down. Finally, install the new deck by reversing the process, ensuring all connections are secure before testing the mower.
Free it up with a good penetrating oil then clean it with soap and water after you get it dry lube it with either powdered graphite or Catapillar Dry Film Lube if you wash your tractor always run it up and down the street to dry out the variatir or you will be going through this again, Mike 214 1986 47" cut
It looks like you can, but it's not advisable. According to a forum post on lawnsite.com, "There is no true front end loader that will work on a 200 series frame, its just too small the front axles will wear out prematurely under the extra weight of a loader". I have no idea if this is credible adivce, though.
On a John Deere 214 mower, the ignition coil typically has two primary connections: one wire connects to the spark plug, while the other connects to the ignition module or the mower's electrical system. The spark plug wire delivers the spark necessary to ignite the fuel-air mixture in the engine. It's important to consult the mower's service manual for specific wiring diagrams to ensure proper connections.
The belt that runs from the variable speed pulley back to the transmission is part number is m44121. it is 67 3/8 long and 5/8 width.
NHL player John Moore weighs 214 pounds.
You will want to buy the John Deere 43" blade. This is a non-hydraulic blade that fits the square fender 110's and 112's and all 210, 212, 214, and 216 tractors. It attaches to a lift kit on the front of the tractor. (Some 200 series tractors came with this lift kit. If you don't have it, you will need to find and install one.) New ones are about $60 at the dealers. After you get everything installed, you lift and lower the blade with the same handle you use to lift and lower your mowing deck. The best places to find the 43" blade are eBay and Craigslist. They usually sell for $125 to $150 or so.
Actors Entertainment - 2009 ActorsE Chat with Danika Quinn and John Michael Ferrari 4-214 was released on: USA: 12 November 2012
30% of 214= 30% * 214= 0.3 * 214= 64.2