0
Fuel OFF time delay module $17.50 AM128906. "After turning the key OFF- the motor runs for 10 seconds to clear the carb" if your motor did not continue to run every-time after the key is OFF you don't have this module. black rubber- 2+" tall- dia size of a nickel. 2 wires are screwed down-the others are pin plugs for Tractor SN# MOG345D120750 newer Try by-pass wiring- locate module and wires- unplug SINGLE YELLOW wire from a clear rubber boot- Now find a cluster of 3 wires inside a clear rubber boot- one of the 3 wires is also YELLOW. this rubber boot has room for a 4th wire- install the 1st single yellow wire into the cluster, When All 4 wires are plugged together inside the clear boot-you have by-passed the module and the motor should start. If it starts-replace the module
What else can I help you with?
What is the firing order of a four cylinder 2040 John Deere tractor?
Type your answer here... John Deere 2040 firing order is 123. There are not that many choices for a 3 cylinder engine
Where is fuse box for John Deere LX 173?
in back of ignition
Where do the wires connect to from the ignition coil on john deere 214 mower?
On a John Deere 214 mower, the ignition coil typically has two primary connections: one wire connects to the spark plug, while the other connects to the ignition module or the mower's electrical system. The spark plug wire delivers the spark necessary to ignite the fuel-air mixture in the engine. It's important to consult the mower's service manual for specific wiring diagrams to ensure proper connections.
How do you change the ignition module on a John Deere x300?
i just done it on a x300r which might be the same.lift the hood up look inside the body where the ignition is.you will see a black connector with maybe 5 wires or so.unplug this and then squeeze inwards the 2 holding clips either side of the ignition with 2 screwdrivers or similar as there is not enough room for both fingers.the ignition barrel will push up and out of the dash. all done !
What is the firing order on john deere 2010 4 cylinder?
1-3-4-2
Where is fuse located on John Deere gt262?
behind the ignition switch on the circuit board. there are two fuses there
What is the function of the igniter on a john Deere lx172 ignition system?
An "igniter" is a subsidiary electrode in an ignitron system.
What is the firing order on the distributor cap for a 1961 john deere 1010 4-cylinder?
1-3-4-2
What is the ignition point gap on john deere 2020?
The ignition point gap for a John Deere 2020 tractor is typically set at 0.020 to 0.025 inches. It's important to ensure this gap is correctly set for optimal engine performance and efficient ignition. Always consult the specific service manual for your model for the most accurate specifications and adjustments.
When mower gets hot it stops runningl111 john deere?
More than likely it is a bad ignition coil.
Were is the time delay module for john deere 425 lawn tractor located?
If you are sitting on the tractor seat (hood up and side panels removed) the time delay module is on the lefthand side (starter side) of your JD 425. The original module is square and the new one is round.
Where is the ignition fuse on Johm Deere F935?
On a John Deere F935 mower, the ignition fuse is typically located in the fuse panel, which is generally found under the seat or near the battery. To access it, you may need to remove a cover or panel. Refer to the operator's manual for specific details on the location and identification of the ignition fuse for your model. Always ensure the mower is turned off and disconnected from power before inspecting the fuse.
