Every 160 000 km if it has Dexcool in the rad.
Code P0174 is System too Lean (Bank 2)
Get a Haynes repair manual for your 2000 Chevrolet S10. Covers most minor service questions like this. Any Autopart store. $17 or $20.
The cylinder #s look like this if u stand in front of the hood 1 3 5(Firewall side/Rear coils)2 4 6(Close to the radiator- front coils)
there are two sensors on a 2000 metro one right after the exhaust manifold and one after the convertor they unscrew like a spark plug if you cant get them out with an adjustable wrench there is a special socket you can get at any auto parts store. then they just unplug at the connector rout the new ones just like the old ones
subtract 13 percent from 2000 = 174013% subtracted from 2000= 2000 - (13% * 2000)= 2000 - (0.13 * 2000)= 2000 - 260= 1740
Buy a new car its a pos
The radiator drain plug on a 2000 Chevy Venture is removed by slowly turning it in a counter-clockwise direction. Care must be taken when re-installing the plug to prevent cross threading.
It is located on the driver's side of the radiator in the lower corner. It is plastic and green in color. Mike
i flush the radiator filled it with antifreeze water .. now i heard i should take out air from inside of radiator or hoses so the air will not block circulation of the water? thank you.
there should be a bleed valve towards the bottom of the rad. It will look like a " T : .
Use a flared end wrench or crows foot to loosen.
Yes
Something is wrong with your 2000 Chevy Venture. Better information get's better answers.
The book time, or time it takes a mechanic,Êto change a radiator in a 2000 Chevy Venture with the 3.4 liter engine is 3.1 hours. It may take slightly a longer or shorter time depending on the exact vehicle year and engine size.
My 2000 Chevy venture gets 24- 25 on the highway.
To remove the radiator drain plug on a 2000 Chevy Venture, you'll typically need a 19mm socket or wrench. It's important to ensure the engine is cool and to use a container to catch any coolant that may spill when you remove the plug. Always check for any signs of wear or damage on the plug before reinstallation.
yes