0
What else can I help you with?
If a clock period is 10 microseconds what is the clock rate?
It is 100000 Hertz.
What is a purpose of time card clock?
The purpose of a time card clock is to accurately know hourly employee's time in the office. This system is being replaced by employees clocking in on the computer.
Which command is used to clear the command window of Matlab?
CLC is the command used for this purpose. CLC clears the command window and homes the cursor
What was the purpose of the clock?
So you can read the time? (I don't know, that's a strange question)!
What is the purpose of an attendance clock?
An attendance clock is used as proof to when an employee began and ended a day of work. It is used to calculate pay so there is no arguement to the amount of time worked.
Why set clock rate in router?
To configure the clock rate for the hardware connections on serial interfaces such as network interface modules (NIMs) and interface processors to an acceptable bit rate, use the clock rate interface configuration command. Use the no form of this command to remove the clock rate if you change the interface from a DCE to a DTE device. Using the no form of this command on a DCE interface sets the clock rate to the hardware-dependent default value.
What command is used to set data speed on a router's serial port to 56 kbps?
The command is: clock rate 56000 So it will appear on the command line interface as: Router(config-if)# clock rate 56000 Reference: Networking by Jeffrey Beasley Chapter 6 page 216.
When must a router serial interface be configured with the clock rate command?
When the interface is functioning as a DCE device
What is the result of using the clock rate 56000 command at the serial interface of the router?
The interface is configured as a DCE device.
Which command must be entered when connecting two routers without external DCE devices via a serial link?
Clock rate.
What is Clock rate in router?
Data Generating Capability of a Device is called Clock Rate. If the clock rate is high, the processing will be slow down. If the clock rate is low, the processing will be high.
In DOS what is the command used to set internal clock?
"time" command.
What is the relationship between clock cycle time and clock rate in a computer system?
The clock cycle time and clock rate in a computer system are inversely related. A shorter clock cycle time allows for a higher clock rate, which means the computer can process instructions faster. Conversely, a longer clock cycle time limits the maximum clock rate that can be achieved.
When did Special Purpose Command end?
Special Purpose Command ended in 2009.
When was Special Purpose Command created?
Special Purpose Command was created in 2002.
What is the relationship between clock rate and clock cycle time in a computer system?
The clock rate and clock cycle time in a computer system are inversely related. A higher clock rate means a shorter clock cycle time, allowing the system to process instructions faster. Conversely, a lower clock rate results in a longer clock cycle time, slowing down the processing speed of the system.
What is the purpose of the AS command in SQL?
If you are in search of learning the purpose of the AS command in SQL, there are a few resources that are available to you. One resource that can explain the purpose of the AS command in SQL is Wikipedia.
