answersLogoWhite

0

Each light-emitting segment is nothing but an LED, which is electrically similar to

any other diode. Once the forward voltage exceeds something around 1.7 volts,

the resistance of the diode becomes very verysmall. At any higher voltage, it

would literally appear as a "short" circuit, without a separate series limiting resistor.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How can I connect LED lights to create a lighting display?

To connect LED lights for a lighting display, you will need to first determine the power source and voltage requirements of the LEDs. Then, connect the LEDs in parallel or series circuits using appropriate resistors to control the current. Finally, use a controller or switch to control the lighting effects and patterns of the display.


How many resistors do they have to make to deliver 5000 resistors?

To determine how many resistors need to be made to deliver 5,000 resistors, we must consider production losses, defects, or any other factors that affect the final count. For example, if they expect a 10% defect rate, they would need to produce 5,556 resistors (5,000 divided by 0.9). Therefore, the exact number of resistors to be made depends on the anticipated yield or defect rate in the production process.


Do you need to put a shunt resistor to connect the ac voltmetr?

Shunt resistors are used with ammeters; voltmeters require series resistors.


Do the resistors lie wwithin the tolerance limits?

To determine if the resistors lie within the tolerance limits, you need to compare the measured resistance values of the resistors with the specified range provided by the tolerance. If the measured resistance values fall within this specified range, then the resistors are within tolerance limits.


Where is the resistor located?

There are many resistors, need to know which one and which vehicle you have.


How are parallel resistors connected?

If you need a resistor of a certain value, and you have no resistors with small enough values,you can create the one you need by connecting several of those you have in parallel.The effective net resistance of resistors in parallel is always less than the smallest individual.And the more resistors you add in parallel, the smaller the net effective resistance becomes.


When does an overpass need to display clearance height?

when does an overpass need to display clearance hight


Why do resistors need to be precise?

A: Resistors are never precise they normally come with 5% tolerance. However if precise tolerance is needed one can purchase a precise resistor down to 0,01% or even lower % but these resistors are special and made special for each application


How will you get 6.75 ohm resistance in combination of resistors bacause i have no any value resistor is available?

6.8 ohms is a standard value, and 6.8 is within 0.74% of 6.75. If you need a precise value, use a potentiometer or start playing with resistors, because resistors have tolerance and you will not be able to build an exact 6.75 by just looking at values - you need to measure combinations.


Which is better 70 ohm or 32ohm?

That is a very difficult question. Need to know in what context these resistors are used for.


What is the total resistance of twelve 5.6 ohms resistors in a row?

If they are in series, you need to add the resistance values.


Can you display a picture of a banni rooster?

You can display a picture of a bani a rooster. The location of the display may need permission from the owner of the location.