18mm
8mm
M12 x 1.25 x 40
Not sure about the hole but the stud size is M12 X 1.25
For an M12 bolt, the recommended hole size for clearance is typically around 12.5 mm to 13 mm, depending on the application and tolerances required. This allows for a small amount of play to accommodate misalignment and facilitate assembly. If you're tapping a hole for an M12 bolt, the ideal tap drill size is usually around 10.2 mm. Always refer to specific engineering standards or guidelines for precise applications.
size is M12 x 1,5 dont know the length of the bolt though
M12 signifies that the shank is 12 mm diameter. The length will vary. +++ Another tip: The A/F size of a standard M12 bolt or nut is 19mm, so close to 3/4" that the latter spanner will work - but be aware that this is the only co-incidence between metric and inch-based fastenings; and the M-series proportions don't follow a very consistent path!
The wheel bolt pattern for a 1999 Chevrolet Lumina is 5 bolts with a spacing of 115 mm. The bolt size is typically M12 x 1.5. Make sure to verify this information, as variations can exist between different models and trims.
The crankshaft pulley bolt for a 1997 Nissan Pathfinder is typically an M12 x 1.25 size bolt. It's important to ensure the proper torque specifications are followed when installing to avoid any issues. Always double-check with a repair manual or parts supplier for the most accurate information specific to your vehicle.
The caliper bolt size for a 1999 Honda Accord is typically M12 x 1.25. It's important to check your specific model and any modifications that may have been made, but this is the standard size for the front caliper bolts. Always ensure you use the correct torque specifications when reinstalling to ensure safety and performance.
M12 1.5mm
M12-1.50
M12-1.50