answersLogoWhite

0

Depending on the size or the bit and the chuck, you can use a "collar " on the bit. Make one out of something that will slide firmly onto the outside of the bit. like the plastic tube from inside a ball point pen, a piece of aquarium tubing, etc. You can also buy 1/4" shank bits with small diameter ends. They are made to use in power screwdrivers, but will work in your drill. Hope this helps !

ANS 2 -When I have this situation I use a 'pin drill' which is essentially a 1/4 steel tube with a 'collet' on the business end that holds tiny drill bits. -I simply fit the shaft of this 'pin drill' into my bench drill's chuck.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

What limits the size of drill bit that can be used on a bench drill?

The size of the chuck is the only limitation. Most bench drills have a 1/2 chuck and many of them are removable. -ie,you can often fit a bigger chuck.


How do you change a drill bit in a drill?

Depends on the chuck. Adjustable chucks can be loosened by hand, simply twist the end of the drill. Older (or heavy duty drills) need a key to open the drill chuck. I have a McKeller cordless 18V electric drill with no hand adjustable or key adjustment visable???? I'm confused


What is the function of tang in a twist drill?

The function of tang is to fit in the chuck.


How do you remove a drill chuck from a drill?

Use a pair of Vise-Grip pliers on the key-less chuck and Channel-lock pliers on the stuck bit. Holding the drill with the drill facing away from you (as in use), turn the chuck clockwise and the bit counterclockwise.


How can I effectively use an expanding drill bit for my project?

To effectively use an expanding drill bit for your project, start by selecting the appropriate size for the hole you need. Secure the bit in your drill and adjust it to the desired diameter. Slowly drill into the material, applying consistent pressure and keeping the drill perpendicular to the surface. Avoid overheating the bit by periodically withdrawing it to clear debris. Lastly, clean the hole and test the fit of your fastener before proceeding with your project.


What are hand drills?

A hand drill can be various things, such as an old fashioned S shaped drilling device that you turn by hand, or a straight drill with a geared wheel which you turn to rotate the bit. In more modern terms,a hand drill is aa electric motor in plastic case that has a chuck in front of it where you can fit drill bits and have the motor turn the bit at high speed.


What tool will be used drilling hole in plasterboard to fit a 15mm copper pipe through?

15mm drill bit and a drill.


What size drill bit should I use for a 1/4 screw?

For a 1/4 screw, you should use a drill bit that is slightly smaller in diameter than the screw itself, typically a 3/16 drill bit. This will ensure a secure fit for the screw.


Will a 6mm drill bit fit into a quarter inch collet?

Yes it will fit, but the collet will have to tightened down quite hard to grip it.


What size is a m20 drill bit?

A 20mm or 13/16 drill bit will allow the bolt to fit through.


What size drill bit should I use for a 1/2 lag bolt?

For a 1/2 inch lag bolt, you should use a drill bit that is slightly smaller in diameter, typically a 7/16 inch drill bit. This allows for a snug fit and proper anchoring of the bolt.


How do you adjust the manual choke on a eldobrock 1405 series carburetor?

you need a pull choke cable to use it manually and then set it so when closed you can fit an 1/8" drill bit between the carb body and the choke flap.