there are high powered nail guns, similar to a 22 pistol. they shoot the nail into concrete. they are available for sale or rent at a local rental outlet. one may also use plastic or metal anchors, by predrilling the cement with a cement bit, tapiin the anchor, pre drill the base noard of the wall, then anchoring the wall with a lag screw into the anchor. adhesive would be a great idea to seal and reduce creaking noises later to come.
To fasten boxes to wood typically wood screws are used. To fasten a box to masonry plastic or lead inserts are used. To fasten a box to a hollow wall toggle bolts can be used. To fasten a box to a concrete wall, drill and insert a wedge anchor or a steel pin can be shot into the concrete with a Hiliti powder activated tool.
The recommended method for filling the gap between a concrete slab and a wall is to use a flexible sealant or caulk specifically designed for concrete applications. This helps prevent water infiltration and maintains the structural integrity of the building.
It is not always mandatory that we will have a RCC bed below any brick wall. In ground floor without basement the brick wall stands on common concrete slab not RCC slab, in other floors slab has to be made of RCC, hence brick wall stands on RCC.
Yes if its your wall. Your neighbor needs to install the post in the ground with concrete. Or another method depending on the surface. Is it dirt, concrete slab?
yup
Use polyethylene sheet membrane. Prior to concrete placing, cover the entire area with a layer of PE sheet membrane extending the perimeter of slab and up against wall for the depth of concrete.
The different setting forms for concrete include slab, beam, column, and wall forms. These forms are used to shape and support the concrete as it hardens and cures into a solid structure.
When choosing exterior concrete wall paint, consider the climate, surface preparation, and paint quality. Clean and prime the surface before applying the paint, and use a high-quality paint designed for exterior use. Apply the paint in thin, even coats for best results.
This question is not clear. A slab alone shouldn't support a load bearing wall, except for a shed type of building.
The wall has a bottom plate or 2x4 laying flat that is nailed to the bottom of the studs. Two top plates at the top of the wall. The wall is built, stood up and nailed down to the floor. If the house is set on a concrete slab, bolts are set in the concrete and the wall is bolted down.
In commercial building the exterior block wall is used as a finished surface. If you have electrical or plumbing needs you can build a stud wall next to the CMU wall. You really don't need to secure it to the Cmu wall as long as there is an adjoining wall to support it or ceiling joists.
bent and tied metal rebar for the slab-to-wall connection at all filled cells bent metal straps embedded into the lintel to connect roof to wall