You can place a small finish nail through the spindle and then "set" it with a nail set.
Dynamat
balance it
The heat shield on top of the converter may have broken loose. it can be repaired. If the rattling is inside the converter it must be replaced.
The best way to stop the rear brakes on a Mazda 626 from rattling would be to replace them. New brakes can cost between $20 and upwards of $100 depending on the quality of the brakes.
Replace it.Replace it.
the muffler rattling? the muffler rattling? the muffler rattling?
To make your snare drum stop rattling, you can try adjusting the tension of the snare wires, ensuring they are evenly spaced and not touching the drumhead. You can also experiment with different types of dampening materials, such as gel pads or moongel, to reduce unwanted vibrations.
There are a few things that might cause an air conditioner to make a rattling noise. It could be that the there is dirt and debris in the cabinet. If this is the case, cleaning the cabinet should stop the rattling. The reason could also be loose panels on the cabinets. The fan could also be bent and no longer straight.
if its a front wheel drive vehicle then it could be the axels
To stop your license plate from rattling, you can use rubber washers or spacers between the plate and the mount to absorb vibrations. Tightening the screws firmly can also help, but be careful not to overtighten and damage the plate. Additionally, you can apply a thin layer of felt tape on the back of the plate for extra cushioning. If the rattling persists, consider using a license plate frame that holds the plate more securely.
tighten torx screws holding glass to sunroof hinge. this is most common cause.
More than likely the heat shield is cracked or loose. Repair or tighten it.