answersLogoWhite

0

To start a Bolen weed trimmer, first ensure that the fuel tank is filled with a proper gas-oil mixture. Next, switch the ignition to the "On" position and set the choke lever to the "Closed" position if the engine is cold. Pull the starter cord until the engine fires, then adjust the choke to "Open" for continued running. Finally, allow the engine to warm up for a few moments before starting to use the trimmer.

User Avatar

AnswerBot

1mo ago

What else can I help you with?

Related Questions

What is the best method for replacing the weed trimmer line on a string trimmer?

To replace the weed trimmer line on a string trimmer, follow these steps: Turn off the trimmer and disconnect the power source. Remove the spool housing by pressing the tabs or unscrewing the cap. Take out the old line and cut a new piece to the appropriate length. Insert the new line into the trimmer head following the arrows for the correct direction. Reassemble the spool housing and test the trimmer.


What is the best way to replace the weed trimmer string on a trimmer?

To replace the weed trimmer string on a trimmer, follow these steps: Turn off the trimmer and disconnect it from the power source. Remove the spool housing by pressing the tabs on the sides and pulling it out. Take out any remaining old string from the spool. Cut a length of new trimmer string according to the trimmer's specifications. Insert the ends of the string into the holes on the spool. Wind the string evenly and tightly around the spool in the direction indicated on the spool. Reassemble the spool housing and reconnect it to the trimmer. Test the trimmer to ensure the string is working properly.


What is the purpose of a line trimmer?

A line trimmer, also known as a string trimmer, is used to trim grass or weeds. The piece of equipment also goes by the name of a weed eater, or weed whacker.


Is there a weed trimmer that uses a dewalt battery?

no


How do You restring a Honda weed trimmer?

You remove the bottom cover off the weed trimmer, and remove the tangled old wire. Insert the new wire into the side of the trimmer and wrap it around the black spindle.


What is the gas oil ratio mix for a homelite st185 weed trimmer?

40:1 owner's manual for a homelite st 185 trimmer says 32:1


What is the past tense of weed-eat?

weed-ate, or cut with the string trimmer


What is weed eater trimmer line made of?

Nylon


How can I change the string on my Ryobi weed trimmer?

To change the string on your Ryobi weed trimmer, follow these steps: Turn off the trimmer and disconnect the spark plug wire for safety. Remove the spool housing by pressing the tabs on the sides and pulling it off. Take out the old string spool and replace it with a new one. Feed the new string through the holes in the spool and secure the ends. Place the spool back into the housing and reattach it to the trimmer. Reconnect the spark plug wire and test the trimmer to ensure the string is working properly.


Which brand of trimmer is the easiest to use and unspool?

The Weed Eater Electric Trimmer is one of the easiest to use


What is gas to oil ratio for 24cc trimmer?

what is the gas/oil mix for the 24cc weed trimmer by craftsman


My craftsman weed trimmer runs on the ground but shuts off when you pick it up?

I solved my own problem,my weed trimmer has a on and off switch the wire in the switch had a bare place that was shorting out, by lifting the trimmer I was putting pressure one the bad connection.