No. When the key is on the tail lights are on.
yes at the bottom turn it clockwise to stiffen
Your battery light comes on because you have an electrical problem. It may be in a switch, a relay, a sensor, or the fans. Since you have to ask, you should have a mechanic check it out.
If it is a single bulb, it is probably the bulb. Many tail light bulbs have two separate filaments, with the turn/brake being much brighter than the marker light. The tail light and turn/brake circuits are completely separate.
Begin I removing the tail light connector. Take hold of the tail light, push in and turn at the same time. The tail light will come on. Reverse the process to install your new tail light.
Engine idle is set too high , turn the idle down should take care of the problem
Because it is broken
To reset the service reminder on a 2004 Polaris Sportsman, first turn the ignition key to the "ON" position without starting the engine. Then, press and hold the "Mode" button on the gauge cluster until the service reminder indicator resets. You may need to repeat this process a couple of times to ensure the reset is successful. Finally, turn the ignition off and back on to confirm that the service reminder has been cleared.
In a 2004 Jeep Liberty, the color code for the tail light wiring is typically as follows: the left tail light uses a brown wire for the tail light and a yellow wire for the turn signal, while the right tail light uses a brown wire for the tail light and a green wire for the turn signal. Always refer to a specific wiring diagram for your vehicle or consult a repair manual for the most accurate information.
You can access the tail light assembly from the cargo compartment. Remove the tail light connector. Grab the lightbulb, push in and turn at the same time. The lightbulb will come out. Reverse the process to install your new tail light.
the bulb with two elements in it is the turn signal and brake light bulb
To set the clock on a 2007 Polaris Sportsman 500, first turn on the ignition without starting the engine. Press and hold the mode button until the display shows the time. Use the up and down buttons to adjust the hours and minutes. Once set, press the mode button again to save the time and exit the setting mode.
This is because the tail light bulb has a different element in the bulb. Just replace the bulb and that will fix the problem.