Four bolts under the rear of the tunnel near the shock mounts ( one front and back of mount ). Remove nuts, lift to clear studs, pull back to release front retainer ( easily ), disconnect wiring plugs. Seat should now be free to remove from sled.
To remove the battery from a 1995 Ski-Doo Grand Touring, start by ensuring the snowmobile is turned off and parked on a flat surface. Locate the battery compartment, typically under the seat or a cover. Disconnect the negative (-) cable first, followed by the positive (+) cable to avoid any electrical shorts. Finally, remove any securing straps or brackets holding the battery in place and lift it out carefully.
You can remove the back seat by pulling on the front edge of the seat with both hands equally spaced apart. If this hasn't been done in a while you'll have to pull hard.
On a 2002 Ski-Doo Grand Touring, the battery is typically located under the seat. To access it, you'll need to remove the seat by unfastening the securing clips or screws. Once the seat is removed, you should see the battery compartment, which houses the battery. Make sure to follow proper safety procedures when handling the battery.
There are 2 bolts on the bottom part of the seat, they are a 13mm if i remember right. Remove those two bolts, pull the seat bottom out, remove the two Torx bolts that hold in the seat belts. Push the seat up to unhook it and pull back and the seat back will come off.
To remove the seats from a 1995 Corvette, you will need to remove the front and rear nuts from the seat frame studs. You will?æalso need to remove the lug wrench that is attached to the seat frame studs.
how do you remove the back seat in the 2003 poniac grand am
Remove the back seat cushion by pushing it horizontally back and then lifting up vigorously. Remove the two large nuts holding down the seat back; lift up and off on the seat back. Remove the rear deck cover by sliding forward. Unscrew the speakers.
Just push back on the seat and lift.
Front? Should be a bolt in each corner of seat
You turn the bolts to the left.
remove the 2 bolts at the bottom of the seat and then remove the bottom of the seat. Then remove the two star bolts at the bottom holding the seatbelts in place, then lift the seat on both sides to remove the back of the seat from its clips. Then your all done
just pull on it!