0
To remove the throttle cable on a 2004 Honda Shadow Aero, first, ensure the motorcycle is off and cool. Locate the throttle grip assembly and remove any necessary covers or screws to access the throttle cable. Disconnect the cable from the throttle grip by loosening the retaining screw, then trace the cable down to the carburetor or fuel injection unit, where you will need to disconnect it from there as well. Once both ends are detached, you can fully remove the throttle cable from the motorcycle.
What else can I help you with?
How do you replace the throttle cable to the gas pedal on a 1998 Honda Accord V6 3.0 Vtec engine?
The 1998 Honda Accord 3.0 liter engine does not have throttle cable. The automobile has throttle linkage. The linkage is connected at each end with a connecting bolt. Remove the connecting bolt to remove the linkage.
How do you replace a speedometer cable in a 1996 Honda civic?
There is not speedometer cable on a 1996 Honda Civic. There is a throttle cable. Top replace this unhook it from the throttle body and gas pedal. Hook on the new cable to snake it through the firewall. Properly hook the throttle cable to the gas pedal and throttle body.
How do you remove the throttle cable on a 1996 Beretta?
pull it out?
How do you change a throttle cable on a 1989 Honda Accord LX?
please tell me
What would cause my Honda rancher when you push the throttle down to spit and sputter?
Clean the carbeurator and lube the throttle cable.
Why does Throttle stick on 1997 Honda Passport?
I had a stuck throttle on my 1996 Passport. The throttle cable had a piece of protective black rubber around the throttle cable between the outer cable covering and where the cable connects to the throttle body. The rubber had began to come apart and some of it was getting inside the throttle cable covering, causing the throttle cable to bind. I removed the rubber piece and cleaned out the cable by covering it with GOOF-OFF and then sliding the cable in and out until my cleaning rag was clean when I wiped off the cable. I did not replace the rubber piece and have had no problems since.
How do you replace throttle cable on 1989 ford bronco?
To replace the throttle cable on a 1989 Ford Bronco, first disconnect the negative battery cable for safety. Remove the old throttle cable by detaching it from the throttle body and the accelerator pedal assembly. Install the new throttle cable by connecting it to the throttle body and fastening it to the accelerator pedal. Finally, adjust the cable for proper tension and reattach the battery cable before testing the throttle operation.
Why does the throttle cable on your Honda Recon have too much slack in it?
Needs adjusted or replaced.
How does a 1967 Honda ca 160 motorcycle throttle work?
It works like a screw. There is a pin on the inside of the throttle tube that, when the throttle is twisted, moves the throttle bar toward the outside end of the handlebar. The throttle bar has the throttle cable mounted into the end of it, so when it moves, the cable is pulled and the engine revs.
Remove carburetors from 1981 Honda gold wing?
Once you un-bolt the intakes, and the fuel line, throttle cable and all hoses, the whole unit should just slide out.
How to Install a throttle cable for a 1985 dodge power wagon?
remove the bad cable and put the good one! ;-)
What is the stock throttle cable length on a 2005 honda vtx 1300c?
Should be 43" from nipple to nipple....
