To adjust the valve clearance on a Haojue 125, first, ensure the engine is cool and disconnect the battery. Remove the valve cover to access the valves, then rotate the engine to set it at top dead center (TDC) on the compression stroke for the cylinder you are adjusting. Use a feeler gauge to measure the clearance between the valve stem and rocker arm; adjust the clearance by loosening the lock nut and turning the adjusting screw until the desired clearance is achieved. Finally, reassemble the components and check the clearance once more to ensure it's within specifications.
What is the valve clearence for a 1985 lt 125
The valve clearance for a 1983 Suzuki LT 125 is typically set between 0.05 mm (0.002 inches) and 0.08 mm (0.003 inches) for both the intake and exhaust valves. It's important to check and adjust the valve clearance periodically to ensure optimal engine performance and prevent potential damage. Always refer to the service manual for the most accurate specifications and procedures.
.06mm intake, .08mm exhaus
.07mm or .003 inches cold.
intake .004mm , exhaus .006mm
Oh, dude, you're really getting into the nitty-gritty with that one! The valve clearance on a Yamaha YBR 125 is typically around 0.05mm for the intake valve and 0.08mm for the exhaust valve. But hey, who's measuring anyway, right? Just ride that bike and enjoy the breeze!
Intake: .004-.006 Exhaust: .006-.008
valve settings on a 2008 yamaha ttr 125
cold intake is 0.003 in or .07 mm cold exhaust is 0.003 in or .07 mm
Q: What are the clearances of inlet and exhaust valves of Suzuki GN 125, and how to adjust the valve clearance. A: I'm giving an approximate answer since none is given here. I've just started doing this and don't know all the terminology. Please improve the answer if possible. :) You have to open the two caps hiding the valves on top. They are size 17. Also open the little bolt in front so you can look inside the motor for the "dead point" while rotating the motor manually. The adjustment is done with a flat screwdriver and the clearance should be between 0.08-0.13mmon both inlet and exaust. You have to use thos flat metal thingies to measure the clearance.
how do i adjust the tickover on a ktm 125 sx 2007 model
ttr 125 have about 73 horsepower stalk but the power to the h cap cilinders is terrible, it doesnt transfer the rog nig to the flex nard.