Spring rubbers won't work?
To tighten the drive chain on a Tao Tao 110cc ATV, first, locate the adjustment bolts on the rear axle. Loosen the axle nuts slightly, then turn the adjustment bolts evenly on both sides to increase chain tension. After achieving the desired tension, re-tighten the axle nuts securely. Finally, check the chain's slack to ensure it's within the recommended range before testing the ATV.
To tighten the chain on a 90cc Arctic Cat ATV, first, locate the chain adjusters on the rear axle. Loosen the axle nut and turn the adjuster bolts clockwise to increase chain tension. Ensure the chain has about half an inch of slack at the midpoint, then re-tighten the axle nut securely. Always double-check the tension after adjustments to ensure optimal performance.
http://www.motioncycle.com/fiche_section_detail.asp It appears you need special spring ring pliers. The spring ring pliers I have are not long enough. I'm currently dealing with the same problem. From looking at the parts breakdown, it's apparent the spring ring is what's holding the plunging joint on.
How do u change 400ex rear brakes?
The KTM 450 XC ATV is a Sport Style ATV equipped with an 447.9cc, liquid cooled, single-cylinder, 4-stroke engine with front and rear disc brakes. The XC ATV 450 has a Double A-Arm front suspension with 10.2 inches of travel while the rear suspension has 10.4 inches of travel. The 450 XC ATV was introduced in 2008 for cross country racing.
from the rear of the machine look on the frame. It's on the side of the frame near the rear stamped in it.
Here is how I replaced my ATV wheel bearings with pictures: http://good-times.webshots.com/album/561075606VXudyM
22X11X10 Rear 22X8X10 Front
There are many different ways you can tell if the rear axle has gone out on a Yamaha 350 ATV. If there is a grinding sound or a slipping when trying to put the vehicle in gear, those may be an indication of this issue.
To adjust the chain on a 2000 Yamaha Raptor 250cc, first, place the ATV on a level surface and elevate the rear end using a stand. Locate the chain adjusters on both sides of the swingarm, then loosen the axle nut using a wrench. Turn the adjuster bolts equally on both sides to achieve the desired chain tension, ensuring there's about 1-1.5 inches of slack. Finally, tighten the axle nut and double-check the tension before lowering the ATV.
what other axle will fit a 94 kodiak 400 rear
To tighten the cam chain on a 1995 Kodiak 400 4x4 ATV, first remove the left side engine cover and inspect the cam chain tensioner. Adjust the tensioner by turning the adjuster bolt clockwise to increase tension, ensuring the chain has no slack. After adjustment, rotate the engine manually to check for any binding or excessive tension before reassembling the cover. Always refer to the service manual for specific torque specifications and procedures.