If it is completely bad, the bike will die as soon as the battery runs out of juice. However, this can be a very suspicious dilemna. You would be served best to have it tested on a computer at the Harley shop. Otherwise you may find yourself spending alot of money fixing the wrong things.
The stator is located behind the compensator sprocket inside the front of the primary cover.
Follow directions in manual for your model.
To do this, you must have the manual.
Many reasons are possible. Bad battery or discharging due to a short in the wiring or bad voltage regulator or stator is bad. Just too name the most common.
On a 2000 Harley-Davidson Heritage Softail, the stator is located inside the engine case, specifically on the left side of the motorcycle. It is situated behind the primary cover and is connected to the alternator, playing a crucial role in charging the battery and powering electrical systems. To access the stator, you would typically need to remove the primary cover and possibly the clutch assembly.
is the stator ,under small round cover on egine.
Remove the cables from the 1995 Harley-Davidson Road Tank motorcycle starter. Remove the retaining bolts. Reverse the process to install the new starter. The starter turns the engine over so it can start.
The Alternator which is also called a Stator is located inside the primary case. You will have to remove the primary coverand the primary chain. The Stator is bolted to the engine at the crankshaft.
Get a shop manual. remove primary cover and primary chain. Remove rotor. Unplug stator from voltage regulator. Remove stator. Reverse process to install. You will need a manual and an impact wrench... at very least.
The primary oil does three things. Lube the clutch. Lube the primary chain . And cool the stator. If Harley thought Dextron would do this, they would have recommended the use of it. Keep your Harley a Harley.
It is located inside the inner primary at the front of the motor below where the voltage regulator is mounted. The voltage regulator will have a wiring harness that plugs into the stator plug on the outside of the inner primary (the stator is located under the plug). You must remove the outer primary and the clutch basket to access the stator.
To check a Harley-Davidson Fat Boy stator, first, disconnect the battery to ensure safety. Remove the stator cover and inspect for any visible damage or burning. Use a multimeter to measure the resistance across the stator’s terminals; it should typically read around 0.2 to 0.5 ohms. Additionally, check for continuity to ground; there should be no continuity, indicating that the stator is not shorted.