answersLogoWhite

0

P.S, this does not only work for just for this scooter given, but also works for many other similar scooters!

  • you get the forks and put the stick ring both on the top and bottom of the forks in the circular gaps then put the headset rings on the bottom.
  • then insert the forks through the deck and slot the headset onto the forks.
  • then loosen the clamp on the clamp on the bars if it it is already a bit to tight to push the clamp to the top of your bars.
  • tighten the clamp, BUT NOT TOO MUCH BECAUSE IT IS ONLY TEMPORARY.
  • make sure that you will be able to slide the clamp back down afterwards because you are only doing this to make it easier so don't screw the clamp on too tight... YET.
  • Once you've done this, if you have an ICS Compression System on your scooter, there should be a small bolt between the top of your forks and the wheel.
  • first, take the plastic cover-like protection thing off of the screw. push that bolt up and then slot the bars on top of the forks.
  • this is the hardest bit because you have to make the bolt screw perfectly into the hole in the middle of the bars.
  • Note: the previous step may take several attempts
  • once you've finally fitted the screw from the forks into your bars tighten it.
  • you can tighten it by either: Getting a small wrench and tightening the bolt. OR... Hold the forks and wheels between your feet so they can't move and tighten your bars by twirling them in a clockwise direction
  • once you have succeeded to do all of this, try and spin your deck around to see how stiff/loose it is.
  • if you want the deck to spin faster, loosen the bars a bit, BUT.. if you want the deck to spin slightly slower, tighten the bars a bit
  • once you've done this, do a drop test (where you drop the scooter from about 2cm high off the floor to see how stable the compression system is) and see if the compression works. if it does not seem to work, you have either left the screw too loose or the bolt is not in the bars properly.
  • once you have checked everything, undo the clamp and slide it down (make sure your bars are straight) and tighten the clamp quite stiff so everything on your scooter is inline.

Thank You For Reading =)

gimme some positive feedback plz

User Avatar

Wiki User

13y ago

What else can I help you with?