0
Buy a manual. It will tell you how. You need to remove the heads.
*
*
You can also fabricate a tool that forks around the pushrod and rests on the cylinder base allowing you to lift the pushrod out of the tappet by slightly compressing the rocker arm - valve spring , same technique to reinstall it
I used a wide automotive drum brake star adjustment tool ( such as
Drum Brake Adjusting Tool -- KD 295 )and cut a deep notch into it, available at almost any automotive parts store
*
*
if you are going to install new adjustable EZ install rods then you can remove the old rods by simply snipping them with a bolt cutter ... yes this is how it is done
What else can I help you with?
How much travel on the clutch pushrod on a '89 Harley Softail?
shovel
How do you remove the clutch hub for a 1981 shovelhead harley Davidson?
remove clutch plates etc. the large bolt around the pushrod is reverse threaded with a locking tab washer, bend the tabs flat, using an impact wrench to remove the large bolt is best. the whole unit will slide right off
How do you remove the battery from a 2004 Harley dyna?
battery removal of 2004 harley dyna
How do you remove a stuck breather gear from a Harley engine?
To remove a struck breather gear from a Harley engine you need to follow the instructions on the user manual.
How do you remove battery from 2013 harley roadking?
How do you remove battery from 2013 roadking
How do you remove immobilizer on 883 Harley Davidson?
In my harley devidson its immobilizer lock could you told me how to unlock
How do you change pushrod seals on 1988 sportster?
To change the pushrod seals on a 1988 Sportster, start by removing the pushrod covers and the pushrods themselves. Then, carefully remove the old seals from the engine case and install the new seals, ensuring they are seated properly. Reassemble by reinserting the pushrods and replacing the pushrod covers, making sure to torque everything to the manufacturer’s specifications. Finally, check for leaks before taking the bike for a ride.
How do you replace a hydro booster on a 1996 Chevrolet 2500 series truck.?
remove the silly clip that holds the brake pedal and brake light switch on the pushrod, try not to damage the clip. Remove the four bolts around the brakepedal pushrod hole.(inside, these are tough to get at, a 3\8 air ratchet makes it much easier). remove the two bolts that hold the master cylinder to the booster.Pull the cylinder off booster. do not remove any brake lines, there is enough flex in the lines to get the job done. remove the three hydraulic lines from the booster. You might have to pry a little to get the pushrod off the pedal. remember the wire hanger on the cylinder bolts when you put it back together. Once the pushrod is back on the brake pedal it goes together really easily
How do you remove starter bendix 0n 1985 harley Davidson fxr?
how do i replace the bendix drive in my 85 harley fxrs
How do you remove the dipstick on a Harley.?
Turn it to the left and unscrew it the pull.
Where is the battery located on a 2004 harley soft tail and how do you get to it?
Remove the seat.
How do you replace the battery on your 2006 Harley Davidson Ultraglide?
remove the seat
