To remove the seat on an Arctic Cat 500 ATV, first locate the seat release mechanism, which is typically found at the back of the seat. Depending on the model, you may need to pull a lever or remove bolts using a wrench. Once the release mechanism is disengaged, lift the seat upwards and pull it away from the frame. Always refer to the owner’s manual for specific instructions related to your model.
Look in the owners manual, or just get down there and see how you would logically remove it (I'm guessing you have to remove some screws).
Is asking
Arctic Cat is the manufacturer of Arctic Cat ATV's.
To remove the seat from a Yamaha 350 ATV, locate the seat release latch or bolts at the rear of the seat. For models with a latch, pull it to unlock the seat, then lift it off the frame. If there are bolts, use the appropriate tool to unscrew them before gently lifting the seat away. Always consult your owner's manual for specific instructions related to your ATV model.
An ArTic Cat does not have a VIN it has a serial number and it is usually on on the frame going down from the seat to the engine harness.while sitting on seat looking to front ,on right or left side ? just bought and is quite muddy. thank you
Keihin pvk 36mm with electric choke
where is stator located on 2004 artic cat 650 vtwin
I don't know but I wish I did, I'm having the same problem
On a 2000 Arctic Cat ATV 400, the voltage regulator is typically located near the battery or under the front plastic body panels. It is often mounted on the frame or near the engine. To access it, you may need to remove some of the body panels or the seat to reach the component. Always refer to the service manual for specific locations and instructions.
Remove skid plate 12mm bolt
2003 FIS 500 4x4 AUTOMATIC MRP (GRN) there is one number inccorect in your vin, but I won't write it here.
None, never heard of a two stroke arctic cat ATV