To replace the primary chain on a Sportster, first, remove the primary cover by unscrewing the bolts and detaching any attached components like the derby cover or clutch cable. Next, remove the old primary chain by loosening the adjuster and taking off the clutch assembly if necessary. Install the new primary chain, ensuring proper alignment and tension, then reassemble the components in reverse order, checking for correct operation before closing the primary cover. Always refer to the service manual for specific torque specifications and procedures.
yes on the bottom of the primary
Get the repair manual, follow the steps
how do you take primary cover off an 86 sportster
Yes, all Harley-Davidson Sportster models have a derby cover. The derby cover is a decorative and functional component that covers the primary drive system, allowing access to the primary chain and clutch for maintenance. It is typically located on the primary case and is an iconic feature of the Sportster design.
Take the rotor and the clutch basket off at the same time
remove the derby ( round ) cover from the primary. fill til it tries to run out. replace derby cover.
remove the round derby cover from the primary. fill until the oil tries to run out. replace the cover.
how do you stop oil leaking from a 2000 sportster primary cover
under the primary is a 3/4" lock nut, loosen that and adjust the screw by looking through the chain inspection hole. When tightened properly there should only by 3/8" vertical play in chain.
Yes, it is has a very important job. It is the primary chain tensioner adjusting nut. The stud is attached to a nylon chain guide and cannot be removed without disassembly.
It is chain drive.
The primary oil capacity for a 1993 Harley-Davidson Sportster is approximately 1 quart (about 1 liter). It's important to use the correct type of oil, typically a primary chain case oil or a specific motorcycle oil recommended by the manufacturer. Always check the owner's manual for precise specifications and maintenance recommendations.