0
Prairie 700 belt light indicator reset procedure requires the 1st safety step of inspecting the belt's integrity by removing the CVT cover. There is an ON/OFF safety switch that must be turned ON if it has been tripped. If tripped to OFF position, this is the cause of quad running rough and at maximum speed around 5 MPH. This is a safety mode to reduce the possibility of the belt jamming inside the CVT cover if it's severely worn or simply too loose and requiring replacement.
If the belt appears in good shape, without cracks, tears, or missing teeth, you should also measure the width of belt for wear and measure it's tension for it's give. Width of 1.13" or more is good, belt tension should not give much more than 3/4 of an inch with about 10 lbs. of pressure. If the belt meets this inspection, your belt should be OK and resetting the belt light indicator can be performed.
Re-attach the CVT cover after the inspection.
Reset procedure: Turn the ignition key to the OFF position.
You will need to find and disconnect 3 sets of cables located above the CVT cover that are tucked under the body of the Quad just under the air filter. One two-wire cable that runs from the CVT cover. And two - 4 wire connectors - one black and one gray. Once disconnected. Once disconnected, re-attach the gray male to the black female.
Turn the ignition ON. The belt light will blink rapidly then it will slow down to 1 second intervals. Let it blink a minimum of 7 times (7 seconds) and then turn the ignition OFF.
Re-connect all the cables. Black to black, gray to gray and the 2-wire connector.
Turn the ignition ON, the belt light should be OFF.
This procedure solves the blinking belt light indicator reset procedure and when the CVT belt safety switch is tripped.
If the indicator remains ON, the Quad requires a professional service check of the belt, clutch and safety system.
What else can I help you with?
Kawasaki 2003 650 v twin ATV how to reset belt light?
Winch cable goes in but will not come out?
Installing drive belt for 1999 Kawasaki Prairie 400 4X4?
To install drive belt on a 1999 Kawasaki Prairie 400 4x4, access the engine area and remove the cover that holds the clutch. Remove the drive belt around the clutch at the right side of the engine. Replace with new.
Where is the VIN on a Kawasaki Prairie 650'?
I believe its on the right side of the bike. Just below the belt cover.
2002 landcrusier timing belt light reset 1hz?
how do i reset timing belt light on 1hz
How do you reset the timing belt light on a Toyota vigo 2006 model?
how to reset the vigo timing belt warning light
How you reset timing belt light on 2008 land cruiser?
what the prucedure timing belt reset
How do you reset timing belt light model 2010 toyota coaster bus?
coaster bus how do you reset timing belt light 2010
2007 Hilux D4D T Belt light reset?
You will first need to properly reset the light. If this does not reset the light, then you may have to manually press it.
Toyota hiace reset timing belt light?
If you have already replaced the belt and the light is still on you will need to remove the lower and upper dash panels and then remove the instrument cluster which holds your speedometer and other devices. The reset button for the timing belt light is behind the cluster.
How do you reset the timing belt light on Isuzu 2.8 turbo diesel?
how do you reset the digital miter timing belt light on Isuzu 2.8 turbo diesel
How to reset t belt light in toyota?
To reset the T belt light in Toyota kindly see your manual or take it to a Toyota accredited car dealer.
How do you reset the belt light on a prairie 360?
It is a complicated process , because you have to reset the computer also . If you want to do it yourself send me an email and I will tell you how. RickMedic40@yahoo.com . Don't let the email address fool you I own a motorcycle repair shop . Rick
