Toped out fully stock with a fmf air filter 45mph
take out links
The chain on a 2000 Polaris Trail Boss 325 is removed by loosening the retaining bolts and applying tension away from the sprockets. The chain can them be slipped off the sprockets and removed.
1.9 quarts
Yes it will fit as long as the sportsman is model is from an 04 and old
On the left side of machine by footrest there is a plastic tank , where you add coolant .
No, it is not. The 300 and 350 are different critters. There are a number of machines in the Trial Boss series, and the 325 and 330 are just two more of them. Though there is some interchangability of parts, it's best to do some homework before "substituting" anything.
Bad oil temp switch
It tops out at 35MPH and wont go any faster because of the rev limiter
To install a starter for a Polaris Trail Boss 325, first disconnect the battery to ensure safety. Remove the old starter by unbolting it from the engine and disconnecting the electrical connections. Position the new starter in place, secure it with bolts, and reconnect the electrical wires. Finally, reconnect the battery and test the starter to ensure it functions properly.
The valve clearance for a Polaris 325 Trail Boss is typically set at 0.004 to 0.006 inches (0.1 to 0.15 mm) for both intake and exhaust valves. It's important to check the specific model year and consult the owner's manual for any variations. Regular adjustments can help maintain optimal engine performance and longevity.
Toped out 47 mph
On a 2000 Polaris Trail Boss 325, the fuses are typically located in a fuse box situated under the front panel or near the battery area. To access them, you may need to remove the front cover or panel. Always refer to the owner's manual for specific locations and diagrams. Make sure the vehicle is turned off and disconnected from the battery before inspecting or replacing any fuses.