0
First you want to raise the rear end off the ground. Then take a ratchet strap and pull the rear bumper and axle together so it collapses the spring and shock. Now you loosen the two pinch bolts at the very end of the rear axle arm. Take a punch and put through the hole of the eccentric axle housing, turn down to tighten or up to loosen, or roll the rear wheels forward or backwards to do the same thing. Leave at least a 1/4 inch of slack in chain. Now tighten the pinch bolts to 60 ft-lbs, remove ratchet strap, and lower rear end. Check regularly for proper chain slack.
What else can I help you with?
What size chain does a polaris 300 explorer have?
520
How do you swap a front sprocket off a 1997 explorer?
it is a 300 polaris explorer
How do you change oil on polaris 300 4x4 xplorer?
how much oil to put in polaris 300 explorer 4*4 98
Where is the starter on a 1997 polaris explorer 300?
On the very bottom between primary & secondary.
How much transmission fluid does a 1996 Polaris explorer 300 4X4 ATV take?
4 ml
How do you get to the starter on a Polaris xPlorer?
To remove the started on a Polaris 300 Explorer ATV first open the hood. Locate the started which will be up against the wall near the driver's side and remove the screws. You can now install a new started.
What is the oil mixture for a 1995 Polaris 300 sportsman?
Idon't know about a 1995 Polaris 300 Sportsman, but I have a 2008 Polaris 300 Sportsman and the main particular oil I use for mine is Polaris brand oil. If your not satisfied with my answer, call your Polaris Company.
What type of oil do i use for a polaris hawkeye 300?
300
How do you remove the starter on a 1996 polaris explorer 300 4x4 ATV?
To remove the starter from a 1996 Polaris Explorer 300 4x4 ATV, first ensure the ignition is off and disconnect the battery to prevent any electrical issues. Remove the starter cover and disconnect the electrical connections from the starter. Then, unbolt the starter from its mounting brackets, making sure to keep track of the hardware. Finally, carefully pull the starter out from its housing.
Where do the hoses go on 1995 polaris 300 explorer carburetor go?
There are three hoses on a Polaris 300 carburetor. The fuel line is the large one. One is a vent hose that goes nowhere, and the oil injector line connects to the small hose connector on the right side, nearest to the air intake. It goes straight out.
How do you adjust carburetor 300 Honda fourtrax?
How do you adjust carburetor 300 honda fourtrax?
Info on 1995 polaris 300?
what do you need to know about
