Usually, on top of the motor, under the gas tank and in front of the air cleaner. This is the typical location due to the fact that the job of the carburetor is to mix fuel and air to create spontaneous combustion required for an internal combustion engine to operate.
ATV carberator adjustment 1996 ATV lt4wd
you have to take out the carburetor and then clean it
on the carburetor
An ATV's engine can get flooded if you hold the throttle open for too long. At the bottom of the carburetor, there is a screw that can be opened to drain it.
To remove the carburetor from a 350 Honda ATV, first, ensure the engine is off and cool. Disconnect the fuel line and any electrical connections, then remove the air filter and intake boot to access the carburetor. Unscrew the mounting bolts securing the carburetor to the engine, carefully detach it from the intake, and then remove it from the ATV. Make sure to take note of any gaskets or seals for replacement during reassembly.
try cleaning your carburetor thoroughly
you have to know the make of the carbeurator. Kehin and Mikuni make most of them i know of.
On a 110cc ATV with a PZ19 carburetor, the fuel line typically routes from the fuel tank to the carburetor inlet. Ensure the fuel line is free of kinks and securely connected to prevent leaks. The fuel should flow by gravity from the tank to the carburetor, and it's important to check for any inline filters that may be present. Additionally, verify that the carburetor's overflow and vent tubes are properly routed to avoid fuel spillage.
will your 4wheeler tend to stoll after pushen the coutch to far on it?
float valve or float are bad
Carburetor not adjusted correctly
Just order a new one, You can find them on the Internet for around $25.