The ignition coil sends power to the spark plug at the right time to ignite the fuel. If it goes bad then the scooter wont run.
To wire a tachometer on a 150cc GY6 scooter, first locate the ignition coil, which is typically near the engine. Connect the tachometer's signal wire to the negative terminal of the ignition coil, as this is where it picks up the pulse signal for RPM readings. Connect the power wire to the scooter's battery or a switched power source, and the ground wire to the frame or battery negative. Finally, ensure all connections are secure and test the tachometer for proper operation.
The ignition coil is inside the ignition distributor.
No. The coil provides the spark and the module tells the coil when to spark.
The 1998 Toyota ignition coil is located on the firewall, in the engine compartment. The ignition coil can be found on the passenger side of the firewall.
REMOVAL PROCEDURE Remove the engine cover. Disconnect the spark plug wires at the ignition coils. Disconnect the ignition coil harness connector. Remove the ignition coil mounting bolts. Remove the ignition coil. INSTALLATION PROCEDURE Install the ignition coil to the bracket. Install the ignition coil mounting bolts. NOTE: Refer to Fastener Notice in Service Precautions. Tighten Tighten the ignition coil mounting bolts to 8 N.m (71 lb in) . Connect the ignition coil harness connector. Connect the spark plug wires at the ignition coils. Install the engine cover.
on the internet.
Where all the wires plug into. That is the ignition coil. The ignition coil is inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil.
did you have your ignition coil replaced? the signs are that the ignition coil is overheating thus you are able to restart after an hour, when the coil cools. also check if your ignition coil has a resistor. if it has, have it checked for continuity. did you have your ignition coil replaced? the signs are that the ignition coil is overheating thus you are able to restart after an hour, when the coil cools. also check if your ignition coil has a resistor. if it has, have it checked for continuity.
1999 Alero how do i test ignition coil pack
Its right above the ignition coil. Infact you have to remove it first to remove the ignition coil.
'Where is ignition coil 2 in a 1998 Nissan maxima'?
http://www.ehow.com/how_4509339_replace-ignition-coil-pack-ford.html