A B5 motor flange is a standardized mounting interface used primarily in electric motors, particularly in industrial applications. It features a square or rectangular shape with four mounting holes arranged in a specific pattern, allowing for easy attachment to various equipment and machinery. The B5 flange is designed to provide a secure and stable connection, ensuring efficient transmission of power and reducing vibrations. It is commonly used in conjunction with IEC motor standards.
The foot-mounted version is also commonly referred to as B3 motor. The DR motor is available with a NEMA "C-face" flange . The "C-face" flange-mounted motor is a motor type with tapped holes in the flanged end shield.
remove top rad hose on motor and then the coolant flange the thermostat is under the flange
Depends on the motor size and the face type...of course.
The igniton timng is 6 degrees BTDC
A boss on a motor flange is a protruding feature designed to provide additional support, alignment, or attachment points for mounting the motor securely to a base or other equipment. It typically has a cylindrical shape and may include holes for bolts or screws to facilitate fastening. The use of a boss helps ensure proper alignment of the motor shaft with connected machinery, reducing wear and improving performance.
Trouble is to get it mounted right. It'd be very rare to find an assembly spot set up to accept both flange mount and foot mount. But assuming the motor spec is the same (power, RPM, etc) it'll work just find assuming you get the alignment right.
On the drivers side of the engine just behind the valve cover. They are cast into the bellhousing flange.
Typically adjacent to the oil filter flange, and on the end of the motor.
1. Remove the instrument panel and pad. 2. Remove the right side ventilator duct. 3.Disconnect the blower motor connector. 4. Push the flange holding hook toward the blower motor, then rotate the blower motor clockwise and remove it from the A/C unit assembly. 5. Installation is the reverse of removal, noting the following: 6. Rotate the blower motor until the blower motor flange holding hook locks securely in A/C unit assembly.
What is B5 numder's
Slip-On Flat Face Flange. It means the face of the flange, the surface the physically touches the next flange is flat as opposed to raised (SORF Flange)
it is a flange that's it