answersLogoWhite

0

Virtually any kind of oil is suitable for lubricating the chain but Harley recommends their own Formula+ brand.

With the bike upright and level, the oil should come just to the bottom of the clutch spring (approximately one quart).

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How do you change the primary oil on a Harley?

locate and remove your primary oil drain plug, once the fluid is removed,remove the derby cover and replace the primary fluid to the approiate level


Where does the primary fluid go on a 2007 Harley Softail Custom?

in the primary cover, you fool


What are the fluid levels on the 2008 road glide?

On the 2008 Harley-Davidson Road Glide, the primary fluid levels to monitor include engine oil, transmission fluid, and primary fluid. The engine oil level should be checked using the dipstick located on the oil tank, while the transmission fluid level can be checked through the transmission's inspection cover. Additionally, ensure that the primary fluid is at the proper level as indicated by the access cover. Regular maintenance and checking of these fluid levels are essential for optimal performance and longevity of the motorcycle.


Where do you fill primary fluid on 1996 harley?

On the primary there is a round (derby) cover. Remove the cover, fill until the oil tries to run out. Replace the cover. We use engine oil in our primaries.


Where do you put oil in primary 2005 road king?

remove the derby (round) cover from the primary. fill until the fluid tries to run out. replace the derby cover.


How do you refill your transmission fluid on a 2002 Harley Sportster?

through the clutch inspection cover. The Primary and transmission share fluid.


How do you change differential oil?

You dont, you just top it up to the screw hole if needed. If there isn't a drain plug, the cover will need removed to drain the fluid. You then reseal the cover and fill the fluid.


How do you change oil in the primary case 1998 FLH?

There are a couple of different ways. One you can crack the seal around the cover by loosing the screws/bolts and allowing the fluid to drain out. Another, you can remove the inspection cover and using a siphon pump. remove the fluid that way. If yours is so equipped, remove the clutch inspection cover and then remove the plug located on the bottom of the primary cover. Drain fluid into a suitable container.


Why no check plug on 98 dodge ram differential?

It should have fluid check/fill plugs on each cover.It should have fluid check/fill plugs on each cover.


Where is the primary fluid fill on a 2007 Harley Softail Custom?

You remove the derby cover (the large round cover on the left side of the bike) and fill there.


How do you check trans fluid on an 02 sportster?

remove clutch cover on left side of primary cover " hold in on cover while unbolting" as to not let the spring fall or move and keeping rubber gasket in place, "bike must be standing level - not on kickstand" oil should cover bottom of clutch basket! oil should be replaced every 10,000 miles. clutch cover should be carefully put against primary cover not to twist or pinch rubber gasket, torque should be 84 to 108 inch lbs. or times by 12 for ft lbs. goodluck.


Primary fluid for 99 sportster and how to put in?

Locate the primary inspection cover on right side of bike (as you're facing bike). It is about 2-3 inches in diameter & held in with two screws. Put fluid in thru this port. Use fluid prescribed by dealer-transmission fluid.