0
What else can I help you with?
How do you test an Ignition coil for a 2003 Harley Davidson Heritage Softail Classic Carborated?
Use an ohmeter to test tesistance where the plug wires connect to the coil-it should read 12,000. now for the the primaray side where the signal wires connect to the coil should be 2-3 ohms.
1972 Harley Davidson sportster wiring diagram?
Look in a book called "Tech-Tips" put out by Easyrider Magazine, there is a simple wiring diagram that I once used on my 72 XLCH it consist of about 6 wires.
Why Harley-Davidson Motorcycle brake lite no working?
Check the lite bulb it is OK check if there is power at the lite when you press peddle/lever.If no power check brake switches and fuses as well as connections on wires.
Why does the starter keep turning when the button is released on a 84 harley Davidson?
You could have a sticking solenoid on the starter, you could have a defective starter button, or your solenoid wires may be set up in a way that causes the current to ark between points when it's not supposed to.
You had a code P0305 on a ford F150 Harley Davidson you replaced the spark plug and the coil but the P0305 code still come back?
Trouble code P0305 means:Cylinder 5 misfire detected Try replacing the plug wires and double checking the spark plug gaps
Location of speedo sensor on a 2002 harley Davidson road king?
rt side top of trans, between top cover and starter. held in by one 1/4 inch Allen head bolt. careful with wires, they are nestled in there tight. it will come out without taking out starter.
What happens when you cross plug wires on a 1988 1200 harley?
the rear cylinder will fire first.
How do you bypass the angle bank sensor on a 1995 harley Davidson sporster?
Bypassing the angle bank sensor on a 1995 Harley Davidson Sportster typically involves locating the sensor's wiring harness and connecting the two wires directly to bypass the sensor. However, it's important to note that doing so can lead to safety issues, as the sensor is designed to prevent the bike from starting if it is tipped over. Modifying or bypassing safety features is generally not recommended, as it can compromise the bike's safety and reliability. Always consult a professional mechanic or refer to the service manual for guidance.
How do you removed starter on 1987 harley daivdson heritage?
Their are some screws over there and you unscrew it and take out the wires also.
How many quarts of oil does a 1997 harley Davidson heritage springer use?
2.5 to 3 quarts. After draining, put in 2.5 quarts, then crank the starter without the spark plugs wires connected. It will allow it to cycle the oil through the motor. Check the oil level and then add the last .5 quarts IF NEEDED depending on where your oil level is.
Harley Davidson heritage classic shuts down while under power Everything goes out After a couple of minutes it will re-fire Ignition switch is hot to the touch?
Voltage regulator a loose connection. Look around the switch. No loose wires or corroded terminals? Get a new regulator and put it on. Really the only way to test it on older bikes.
Why does 1998 Harley-Davidson shut off?
most likely you have a broken wire .you need to run the bike and move wires until you hear the bike start to stall .I would remove the seat .and get behind the oil tank that's where my problem was on my 76 super glide .she would stall out in the middle of the parkway it was crazywhen I had enough I and stripped and rewired the whole bike one wire at a time .and on a 76 superglide the headlight held most of the wires.but i found stripped wires touching the oil tank .after that the bike never stalled again.good luck
