answersLogoWhite

0

Bypassing the angle bank sensor on a 1995 Harley Davidson Sportster typically involves locating the sensor's wiring harness and connecting the two wires directly to bypass the sensor. However, it's important to note that doing so can lead to safety issues, as the sensor is designed to prevent the bike from starting if it is tipped over. Modifying or bypassing safety features is generally not recommended, as it can compromise the bike's safety and reliability. Always consult a professional mechanic or refer to the service manual for guidance.

User Avatar

AnswerBot

3mo ago

What else can I help you with?

Related Questions

Where is the speed sensor on a 2003 Harley Davidson FLHTCUI?

On the tranny.


Where is the sensor for a 95 harley Davidson digital speedometer?

a 95 harley does not use a digital speedometer. If urs has one, it is probably aftermarket modificiation.


Where is the speedo sensor on a 1998 harley Davidson Dyna Wide Glide Evo engine.?

on the bike somewhere


Where is the speedometer sensor on a 2000 harley Davidson ultra classic located?

on top, right side of trans


Where is the bank angle sensor located on a harley Davidson?

It's under the seat and bolted to the rear fender.


Where is the speedometer sensor on a 2003 harley Davidson road king?

top right side of the transmission, toward the rear.


What effects will a bad cam sensor have on a harley Davidson 883 sportster?

wont fire, timing off, backfiring


Is there a speedometer sensor on a 2000 harley Davidson ultra classic?

If you don't have a speedo cable on your front wheel, you have a speedo sensor. I believe that change was made in 2000.


How do you remove the speedometer sensor on a 1999 harley Davidson 1200 sportster?

To remove the speedometer sensor on a 1999 Harley Davidson 1200 Sportster, first, disconnect the battery to ensure safety. Locate the speedometer sensor, which is typically found on the side of the transmission. Use a socket or wrench to unscrew the sensor from its mounting position, then gently pull it out. Make sure to check for any wiring connections and disconnect them if necessary before fully removing the sensor.


How do you replace speed sensor on a 2000 Harley Davidson flstf?

Info on the Road King Forum about it...http://forums.delphiforums.com/Live2Ride/messages?msg=35643.2


Will a 2006 Harley Davidson sportster exhaust fit a 2007 Harley Davidson sportster?

Unfortunately not: The 07 Sporties are EFI (fuel injected), thus requiring o2 sensors (and sensor bungholes) in the exhaust. 06 bikes, on the other hand are use a cv carb that does not need the sensors or bungs.


How do you clean Harley Davidson speedometer sensor?

The speedometer sensor is lovande On rop tight of the tranny, loosen The vilt and lift The sensor up, there should be a O-ring so be careful when you lift it up! then sand The sensor genre and clean it carefully. Done!