answersLogoWhite

0

fuel pressure regulator with reference port

turbo

intake

fuel line

cylinder base gasket to lower compression

fuel pressure gauge

boost gauge

blow off valve

2 inch thin pipes and cilicone elbow

a lot of time.....

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How much is a 1997 Suzuki gsf bandit 1200 worth?

£6,500 or $9601.80


WHAT IS Recommended oil for suzuki 1200 bandit?

10w 40 its on the side of the bike lol


How do you remove brake pistons from caliper Suzuki Bandit 1200 K4?

The easiest way is to leave the hose connected after you have it off the bike and pump it out with the peddle.


How many quarts of oil does a Suzuki bandit 1200 take?

The Suzuki Bandit 1200 typically requires about 3.2 quarts (or approximately 3 liters) of oil with a filter change. If you're just changing the oil without replacing the filter, it may take around 2.8 quarts. Always refer to the owner's manual for the most accurate specifications and recommendations for your specific model year.


What is the tire pressure for a suzuki 1200 bandit?

front trye is 120/70/zr17=36 psi and rear tyre is 180/55/zr17=36 psi


Where is the fuse located for instrument panel 01 suzuki bandit 1200?

lift the seat. behind the locking mechanism you'll see two small black blocks. one of them says FUSE on it.


Where is the 30 amp fuse for the ignition located on a 2005 suzuki bandit 1200?

On a 2005 Suzuki Bandit 1200, the 30 amp fuse for the ignition is typically located in the main fuse box, which is found under the seat or near the battery. To access it, remove the seat and look for the fuse box cover. Once opened, you should see the fuses, with the 30 amp ignition fuse clearly marked. Always consult the owner's manual for specific details and locations.


How do you check oil level in 2001 suzuki 1200 bandit?

To check the oil level in a 2001 Suzuki 1200 Bandit, first ensure the motorcycle is on a level surface and the engine is off. Remove the oil filler cap and wipe the dipstick clean, then reinsert it without screwing it in and remove it again to check the oil level. The oil should be between the "low" and "full" marks on the dipstick. If it's low, add the appropriate oil type until it reaches the correct level.


How do you change fork seals on suzuki bandit 1200?

To change the fork seals on a Suzuki Bandit 1200, start by removing the front wheel and brake calipers, then detach the forks from the bike. Use a fork seal driver tool to carefully remove the old seals and clean the fork tubes. Install the new seals, ensuring they are seated correctly, then reassemble the forks with fresh oil. Finally, reinstall the forks onto the bike, reattach the wheel, and ensure everything is tightened to the manufacturer’s specifications.


What is the value of a 2004 Suzuki dr 650?

1200


Where is the oil filter1200 bandit?

On a Suzuki Bandit 1200, the oil filter is typically located on the right side of the engine, near the front. It's usually accessible from the side of the bike, making it relatively easy to replace during an oil change. Always ensure the engine is cool and properly supported before attempting to change the oil filter.


Does the Suzuki bandit 1200 have a reserve petrol tank?

Yes and no, I have a 2002 bandit 1200s, it has a reserve switch to the left of seat... You need to switch to reserve by around 115 miles ridden or the bike will slow at throttle and shut off. It has a gravity feed hose below normal hose, that is reserve, just simply turn the knob "arrow up" and it will go to reserve.