0
On a 2000 Suzuki Intruder 800, the tool kit is typically located under the seat. To access it, you usually need to remove the seat by unscrewing any mounting bolts or clips. The tool kit may be housed in a small compartment or pouch beneath the seat. Always consult the owner’s manual for specific instructions and details regarding your model.
What else can I help you with?
Where is the tool box in a 1993 Suzuki intruder?
under the passenger back rest. The rest cushion pops out to allow the key to open the tool compartment cover
Where is the tool compartment on a 1997 Suzuki 800?
On a 1997 Suzuki Intruder 800, the tool compartment is located in the sissy bar. Just remove the back rest cushion (it pops off) and use the key to open the compartment behind it.
Where is the neutral switch on a suzuki intruder 1500?
it is in the cver right in front of the tool compartment where the shift rod hooks up to ngine it is right in front of it has two screws holding it in and has one wire going to it
Does a Suzuki intuder 800 vs have a tool kit?
The tool kit on my 2001 Suzuki 800 Intruder is located behind the backrest cushion, its a hard plastic compartment behind the cushion .... gently pry or pull off the backrest. The cushion it pulls straight off towards the front. It has a keyed lock, remove cover revealing a pouch of tools. Hope this helps
How do you remove 1993 suzuki intruder 1400 front turn signals?
To remove the front turn signals on a 1993 Suzuki Intruder 1400, first, locate the mounting screws or bolts securing the turn signal housings to the bike. Use the appropriate tool (usually a screwdriver or socket wrench) to remove these fasteners. Once the signal is loose, disconnect the wiring harness by gently pulling apart the connectors. Ensure you handle the wires carefully to avoid damage.
How do you remove a seat on a Suzuki intruder 1400?
To remove the seat on a Suzuki Intruder 1400, first, locate the seat release mechanism, which is typically a bolt or latch under the rear of the seat. Use a suitable tool, like a socket wrench, to unscrew the bolt or pull the latch. Once released, gently lift the seat from the rear and slide it forward to detach it completely from the bike. Make sure to check for any additional clips or fasteners if the seat feels secure.
How do you open tool compartment on your 2004 Suzuki GSX r 600?
How do you open tool compartment on your 2004 Suzuki GSX r 600?
Where is the tool compartment on a Suzuki S50?
the tool pouch is in the fake air cleaner
How do you take the kick start off a 2000 suzuki rm 250?
there should be screws and nuts on the inside of the exhaust connecting it to the body, if not then it is an exhaust that needs a sprecial tool, is it a factory exhaust or not? =]
What tool do you usefor a hayabusa motormounts?
I use my Matco tools on my Suzuki.
Where is the oil drain on a intruder 1500 located?
On a Suzuki Intruder 1500, the oil drain plug is typically located on the underside of the engine, near the bottom of the oil pan. It is usually a hex or socket-type plug that you can identify by looking for a round, metal piece with a threaded opening. To drain the oil, you'll need to remove this plug using the appropriate tool. Always ensure the bike is on a level surface and allow the engine to cool before attempting an oil change.
When was Tool Omri created?
Tool Omri was created in 2000.
