answersLogoWhite

0

Ok i had this motor on my go kart. i had a header on it and a fire sloted head also. i was driving it hard for awhile and the rod broke in 5 pieces and the piston warped and messed up the crankshaft . So i put new rings in it and a new rod and cranksaft. The motor has good fire and the valves are not sticking i tried pouring a little gas in the carb. the motor turns over good it ran fine before i blew the rod. I cant get the motor to start i have no idea why.the gas in the carb is oily to i dont know if its a valve guide or what. Could i have installed the rings wrong i have no idea,.... Any help would be appreciated

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

5hp Briggs and stratton spark plug gap?

.030


How much oil goes in a Briggs and Stratton 5hp engine?

1ml


What type of oil does a 5hp Briggs anf stratton take?

SAE 30


Why does your Briggs and stratton 5hp engine throw oil out of the overflow?

Run the car good


Points gap on Briggs and stratton 5hp model 1112?

All the small Briggs engines seem to have a points gap of 0.02 inches


How much compression is good on a Briggs and Stratton 5hp engine?

any where from 120 lbs to 180 lbs


What spark plug does your 5hp Briggs and stratton lawn mower use?

A Champion CJ8Y or J19LM will perform fine


What is the spark plug gap for a Briggs and stratton 5hp outboard motor?

0.030" for a champion or 0.020" for NGK and others.


What is the correct spark gap for a Briggs and stratton 5hp lawnmower?

The spark plug should be gaped at .030"(76mm)


Why does your 5hp Briggs and stratton die when you give it gas?

It may be one of two things. Either it isn't getting enough gas, or to much


Where are timing marks on 5HP Briggs and Stratton?

On a 5HP Briggs and Stratton engine, timing marks are typically found on the flywheel and the engine block. Look for a notch or a mark on the flywheel, which aligns with a corresponding mark on the engine block when the piston is at top dead center (TDC). These marks help ensure proper timing during assembly or maintenance. Always refer to the specific engine model's service manual for detailed guidance.


Why is your Briggs and stratton 5HP carbureted engine not getting fuel?

The most common reason for a carburetor not to receive fuel is a plugged fuel line. The fuel filter can also be plugged.