0
either your float level is set too high or there is gunk between the float needle & seat inside the carb. open em up, set the float level to the proper specs. pull the needle & seat and clean & polish them. if the needle & seat are too far gone, order new ones and replace.
What else can I help you with?
Why does your Mikuni Carb leak fuel from the overflow at high RPM's?
float height
Why does the mikuni carb leak gas out the overflow when bike and petcock off?
If the Mikuni carb is leaking gas out of the overflow despite the petcock being off, it usually indicates a stuck or damaged float needle valve. This valve controls the flow of fuel into the carburetor; if it doesn't seal properly, fuel can overflow. Additionally, debris in the fuel system or a malfunctioning float can also lead to improper fuel levels, causing leaks. It's essential to clean or replace the float needle and inspect the float for any issues.
What type of carb does a suzuki quadrunner 230?
my quad runner 230 has a mikuni carb on it. the only model numbers on the carb are this 35B/10.
What model mikuni carb fits 850cc norton commando?
You can use either a single Mikuni VM 34 or VM 36 on the 850. The 750 uses only the 34.
What size is the carb for a Yamaha it 250 enduro?
It uses a Mikuni 38 mm carb with round slide. 43mm x 66 mm spigot and mouth.
What is the size of the factory carburetor for a Yamaha yz 465?
The OEM carb on a YZ465 is a 38MM Mikuni VM roundslide.
Why is gas running out of carb overflow tube on 1996 kawaski 1500a?
float is stuck on bad if the bike has set up for a while clean carb on try some sea foam fuel treatment seems to work pretty good might check the fuel filter for trash rust dirt
How do you identify a mikuni carb?
Go to Mikuni Corp.'s website and there is a pdf file that gives the dimensions of their carbs so you just have to measure the one that you have and compare it to the specs on the chart and to find out which one you have. Hope this helps :)
What makes mikuni carburetors die when giving it gas?
Too lean of a mixture. See if a jet is not clogged and clean the carb.
What causes gas to pour out of the overflow hose on a new mikuni carb?
It may be caused by a poor needle and seat. The needle or seat may be clogged with debri allowing fuel to continuously flow into the bowl and out the overflow tube. Check this theory by removing bowl, and reinstalling fuel line and carb to engine and allow fuel to flow. Once flow has begun gently push float into the most highest point. Fuel should shut off. If it does not, then you need a new needle and or seat.
How do you adjust float in a Mikuni carb?
Follow this link, should tell you everything you want to know: http://www.factorypro.com/tech_tuning_procedures/tuning_float_height_adj_procedure.html
Will a 1984 kx 125 Mikuni carburetor fit in a 1987 Bike?
Yes it will fit, I have a 98 carb and my 86 model kx125
