answersLogoWhite

0

If your 1988 Honda FourTrax 300 only idles with the choke on, it likely indicates a fuel delivery issue, such as a clogged carburetor jet or air filter. The choke enriches the fuel mixture, compensating for insufficient fuel reaching the engine. Additionally, there could be a vacuum leak or an issue with the fuel system, such as a bad fuel pump or fuel line obstruction. Cleaning the carburetor and checking for air leaks are good first steps to diagnose the issue.

User Avatar

AnswerBot

1mo ago

What else can I help you with?

Related Questions

1988 Buick Riviera cold idle adjustment?

choke idle adjustment on 1988 Buick Riviera


How do you adjust the idle on a Honda Fourtrax?

under the carb you will see a little black knob. turn it which ever way until the idle gets to the way you want it


How do you adjust the idle on a 1998 Honda Fourtrax?

To adjust the idle on a 1998 Honda Fourtrax, locate the idle adjustment screw, typically found on the carburetor. Start the engine and let it warm up, then turn the screw clockwise to increase the idle speed or counterclockwise to decrease it. Aim for an idle speed around 1,200 RPM, ensuring the engine runs smoothly without stalling. Always make small adjustments and recheck the RPM to achieve the desired idle speed.


Where is the idle screw located on a 2001 Honda CR250R?

I believe the idle adjustment is on the choke plunger, twist clockwise or counter clockwise.


Where is idle adjustment screw on 1997 Honda fourtrax?

On the carb, on the bottom side facing out. should be a black knob you can turn with your fingers.


1991 Honda fourtrax 200 dies unless you give it gas?

adjust the Idle screw... im not sure where it is on the 1991 model but it exists...


Where is the idle screw for a 1988 rm 80?

well it depends on whatcarberator you have on it if yours have the choke on the side that you pull up then you idle it by turning the choke after you pull it up if your choke pulls out from the side then look on the right side of the carb and there will be a screw on the right side turn it too the right to get it to idle hope i helped


What is a normal idle for a 1988 prelude?

my 1988 4ws Honda prelude idles low at 600 rpm


How do you lower the rpm's in a carberated 1988 Honda Accord LX?

If adjusting the idle speed isn't working, check the choke. If that's not it, check the carberator chain. It's a fairly common problem, though the answer usually differs.


Where is the Idle adjust on a 1995 Honda magna 750 vtwin?

No such thing as a magna 750 vtwin. They're a V4, and the idle adjust is a plastic thumb screw pointing down right next to the choke.


Why would a 1988 Honda Accord sputter and lunge at idle when your foot is on the brake?

Carburetor needs rebuilding, most likely.


How do you set the choke and idle on a 1986 s-10 blazer?

That vehicle is throttle body fuel injected, there is no choke or idle adjustments. You have other issues such as a large vacuum leak causing your idle problem.