No, the 86 has 7 clutch plate and the 85 has 6 so the 85 clutch cover is not deep enough. I had the same issue
What diagram are you looking for ? engine,wiring,frame,?
Yes, the 1985 Honda FourTrax models, such as the TRX125 and TRX200, are equipped with a clutch cable. This cable connects the clutch lever to the clutch mechanism, allowing the rider to engage and disengage the clutch for shifting gears. However, the specific configuration may vary depending on the model, so it's essential to refer to the owner's manual for detailed information.
Yes I have one on mine. A smaller Squish band and a little more compression too.
http://en.allexperts.com/q/Motorcycle-Repair-837/1985-Honda-Shadow-Clutch.htm
hi, you may find that it dose not have a clutch cylinder, as this model usually has a cable. confirm this by following thru from top of clutch pedal. regards razzel
To adjust the clutch on a 1985 Honda CRX, first locate the clutch cable adjuster near the firewall. Loosen the lock nut and turn the adjuster to either tighten or loosen the cable tension, ensuring there’s about 0.5 to 1 inch of free play at the pedal. After adjusting, tighten the lock nut and test the clutch operation to ensure smooth engagement. If necessary, repeat the adjustment for optimal performance.
The cover to the right of the kick start that has 3 bolts
I use Motul 10w40. Good for the engine, clutch and stator. Check with your Honda dealer.
It is a Honda Accord that was manufactured in 1985
Look at the back of the engine where the clutch line goes in the engine. 3 bolts to take out and it's in your hand.
Wuzzles - 1985 Klutz on the Clutch 1-6 was released on: USA: 19 October 1985
Eng oil capacity 1985 Honda 200 m atc?