no, but you do need a power source, such as a cell or a power pack if you do not want to use a battery.
The voltage of the battery, and the resistance of the circuit (including the resistance of the wire and the internal resistance of the battery).
The circuit won't do anything until both terminals of the battery are connected to the correct [two different] points in the circuit. As long as either terminal of the battery remains disconnected, the circuit is "OFF".
vinegar makes a battery because of the ions in the vinegar which was reacting to the metal which gives of a electric circuit
It doesn't matter where the bulb is in respect to the battery, as long as the circuit is complete, the bulb will light up.
A battery snap in electronics is what you connect a battery to. The battery snap then sends the electricity in the battery to the rest of the circuit. It's that simple.
You need a Battery, Light Bulb, Ammeter, Switch.
Lightbulb(load),Battery(Power source),Switch,Copper wire
you can see that the battery needs battery so that's why
A 9 volt is to strong so you should probably use a C or a D battery (Cell)
To find the net resistance of the circuit connected to the battery in the figure, you need to calculate the total resistance by adding up the individual resistances in the circuit.
The purpose of the battery in a circuit is to wive energy to the circuit
The purpose of the battery in a circuit is to wive energy to the circuit
i need the answer
(mA of current the circuit draws from the battery when it's running) multiplied by (number of hours you want the circuit to operate from the battery) is equal to the absolute minimum mAh rating the battery must have.
Both a Genecon and a battery can serve as sources of electrical energy in a circuit. When connected, both can provide the necessary voltage for current to flow and power the devices in the circuit.
To make a light bulb light up, you need a closed electrical circuit. This circuit typically consists of a power source (such as a battery or outlet), wires to carry the electricity, and the light bulb itself. When the circuit is complete and electricity flows through the bulb, it will produce light.
You actually only need two things to make a circuit. One is a power source, such as a batter, and the other is a conductive metal, e.g. copper wire. All you need to do is touch one end of the metal to one pole of the source, and the other end of the metal to the other pole, then vioala! You have a circuit.