Lexus GS300 Brake Light Bulb Troubleshooting (check in this order):
· Check Fuse(s)
· Check Brake Bulbs - Including bad bulbs, loose connected or incorrectly installed bulbs, left, right and center high mount - 1 bad bulb or connection in the circuit can cause the entire circuit to malfunction.
· Check Turn Signal Bulbs
· Check switch on brake pedal
· Check license plate light bulb and wiring (sometimes on same circuit)
· Check trailer hitch wiring harness (sometimes on same circuit)
· Check all wiring harnesses and wiring for shorts
Most likely it's the fuse or a burnt bulb breaking the circuit. Sometimes the license plate and/or the trailer hitch is wired into other circuits and can cause issues in other areas. Sometimes its wires grounding out somewhere on the vehicle. See sources and related links below for bulb information. See owner's manual for location and identification of fuses.
If the needle is out you have to replace the needle itself as its an LED light. If its a dashboard light then you have to remove the face plate(two screws on the top of it) and take out the instrument cluster, take it apart and replace the bulb. Although the needles are engineered to be removed/replaced, you cannot buy a single needle. You must by the entire instrument cluster to fix this.
check your door contact
You will need to remove the dashboard panel in order to replace the electronic throttle control light. With the dashboard panel removed the light can be access to be replaced.
change the bulbs and fuses
Did you recently change or install something in your car like a stereo or GPS?
fix your brakes
check your tires,aliment,balance,control arm shocks, most important the ball joints
Check your brakes and rotors
how do you fix brakes on a 2002 Cl 500 Benz
If you're asking about the starter solenoid, you don't repair it, just replace it. Once they're acting up it generally means that the electrical contact surfaces have failed and you won't be getting any more service out of it. Replace the entire starter.
Are you sure it was the ABS light and not the Brake light? The Brake light indicates a leak in the system. The ABS light indicates a sensor gone bad.
Will require more specifics, what part you want to fix in the rear brakes?
There are a number of places that fix brakes. Midas is one of the most well know places, but there are also local companies who can change your brakes.
I would assume it will cost anywhere from $100- $300 to fix your car brakes. Because they are an important part of your car it can be expensive to fix them .
bleed brakes
It means there is a malfunction in the brakes, the computer will need to be scanned and the problem repaired.
Are you talking about seized brakes? As in the wheels no longer turn because the brakes are stuck? or.......?