The "RS" in RS flip flop stands for "Reset-Set". The RS flip flop has a Reset and a Set input. You can reset or set the flip flop as desired. Output state will be held based on whichever input was last asserted.
Inverter, comparator, RS flip-flop, and transistor
D flip-flop
Replace the T input by sbar rbar q bar + sbar r q
Hello The difference between an active low and an active high SR flip-flop is that with the active low SR flip-flop, the system is activated when the inputs to system are zeros while with the active high SR flip-flop, the system is activated when the inputs to the system are ones.
Yes, a flip flop is a type of electronic logic circut. It is a bistable device, capable of being in one state or the other, "remembering" that state, until some signal triggers it to change state.A flip flop is also a type of foot wear, but this was an electronics question. :-)>
yes it is
flip-flop is a one bit memory device which stores the last output in memory. the output of flip-flop is based on the present input and past output. RS stands for reset-set flip-flop means that for particular value it sets and resets automatically based on inputs.
The JK flip-flop is not better than an RS flip-flop...it's just different. The selection of one or the other depends on what you are trying to do in your digital circuit design.
same, just invertment of each other
two crosscoupled inverting gates form a Reset Set flipflop.
Inverter, comparator, RS flip-flop, and transistor
can intestant flip flop
D flip-flop
in SR flip flop when we have S=1 R=1 we get intermediate state In JK flip flop we eliminate the intermediate state by complement Q- ( J=1,K=1 Q+ = (Q-)') so we can say that JK flip flop is refinement of SR flip flop Amjad Al.Haqpani
Toggles flip flop
when you walk, it makes noises
you don't