photoelectric sensor-sense both metal & non-metal
proximity sensor -sense metal only
The exact mounting location of the turbine speed sensor will differ between brands of vehicles. The sensor will be mounted either on or just below the turbo, and will be a screw in unit with two wires.
Oxygen (A/F) Sensor Heater Control Circuit Low (Bank 1 Sensor 1)symptomsOther than the MIL light illuminating you may not notice any performance issues.causeA short in the O2 sensor heater circuit or the sensor itselfA faulty O2 sensor heaterWiring or connectors are broken or frayed to the sensor or relayBad PCM or ECMThe fixCorrect wiring short or loose connector found in inspection.and/orReplace the bank 1 sensor 1 O2 sensor
The 2003 Mondeo does not have a IAT Sensor is has a Temperature and Manifold Absolute Pressure Sensor (TMAP) The TMAP sensor fits directly into the inlet manifold and accurately measures the vacuum from the engine. The TMAP sensor consists of a temperature sensor and a pressure transducer and therefore replaces the IAT and the MAP sensors. The TMAP sensor provides the powertrain control module with information relating to inlet manifold vacuum and barometric pressure along with the temperature of the air in the inlet manifold. With the ignition on but without the engine running the sensor reads barometric pressure and when the engine is running, the sensor reads inlet manifold vacuum.
Depending on the year of the Monte Carlo the 02 sensor could be installed in several places on the exhaust. The 02 sensor screws in. You may need a special socket to remove it, just unscrew the sensor and screw the new one in.
I think the sensor are on the gearbox , and send it to the transmision ecu
A limit switch turns on or off when the object being sensed reaches a specific location.A proximity sensor returns an analog signal indicating how far the object is from the sensor.
The smoke detectors use the photoelectric effect or a sensor based on the ionization differences between smoke and air.
A proximity sensor emits an electromagnetic field or a light beam and detects any object within its range by measuring changes in the field or beam. When an object comes close to the sensor, it causes a disturbance in the field or beam, and the sensor registers this change to trigger a response, such as turning off a screen during phone calls.
metal detector is sensor
A sensor or a proximity sensor is typically used to detect and distinguish between objects located nearby.
Proximity sensor allows the Mobile display to off during call when mobile is near to ears.
What_is_the_difference_between_proxy_switch_sensor
tion
no difference. both are located underneath the car by the tranny.
I would say that they are one and the same.
same thing
One monitors pressure and the other monitors temperature.