If you mean the song at the endfight when Chef is on fire I think it is
REO Speedwagon - Keep on Loving You
(This was the song I've been looking for quite long)
If it isn't this song you probably will be happy about this link:
There are all songs appearing in Crank 2 listed on:
http://reelsoundtrack.wordpress.com/2009/04/17/crank-high-voltage-songs/
high kareoke
Power houses uses high transmission voltage to supply places that are far away from the generation site. When in regards to distance the voltage is primary and the higher the voltage the greater the travel (using appropriate cable sizes etc). This voltage will suffer some loss during trans missioni but will arrive at its destination with a voltage drop that will not greatly affect the point of demand. keep in mind that this transmission is usually converted to Low voltage via a transformer before it is distributed to the end user. Hope that helped:-)
The end song was written for the show, it is not a purchasable song.
the answer is Destiny By PLAY I Found out on youtube check it out love loads rachel
The song at the end of dolphin tale is called Safe. It is by Westlife.
At the end of the compression stroke. That's one of the jobs of the crank sensor.
That song is called "Crank It Up" by The Young Goulets.
high kareoke
12 volts on the low end, 18 volts on the high end.
A method of stress control is controlling the distribution of dielectric stress. Uniform distribution of dielectric stress may be achieved in high voltage cables by surrounding the high stress areas of the high voltage cable with a tube of high permittivity material that makes contact at one end with a ground electrode contacting the shield of the high voltage cable.
end cell voltage
High resistance on the feeder to the load will cause voltage drop at the load end of the circuit. If this is happening, do the calculations for voltage drop, using the amperage of the load, voltage of the load, the size of the wire feeding the load and the distance from the distribution panel to the load.
that main resign is high voltage is voltage value is high that same time current value is very low. easy to transmission to long distance consumer(HT required consumer) end we have not voltage loss and current also and conductor cost is reduced that is conductor thickness low ,so current level is low
Ferranti Effect causes the receiving end voltage to be more than the sending end voltage. It occurs mainly in long transmission lines when they are lightly loaded. In this condition, the inductance of the lines becomes more resulting in increased receiving end voltage.
The song is by Ace Hood - "Guns High".
One Republic - Mercy
Sunday Girl- high & low