Try looking for a sticker on the underside of the hood. If it's a 2.6, it should be 8 degrees BTDC.
Blackout - 1988 1988-03-10 was released on: USA: 10 March 1988
Blackout - 1988 1988-03-09 was released on: USA: 9 March 1988
1988 Independence Bowl - 1988 TV was released on: USA: 23 December 1988
Rock and the Alien - 1988 was released on: USA: 1988
1988 National League Championship Series - 1988 was released on: USA: 4 October 1988
Timing belt replacement on 88 mighty max
when my 89 mighty max did this I had to push the tailgate in while I opened the handle. Once open adjust or graphite the connections
Yes, the 1988 Mitsubishi Mighty Max is equipped with an interference engine. This means that if the timing belt fails, it can potentially cause the pistons to collide with the valves, leading to significant engine damage. It's important to maintain the timing belt and replace it according to the manufacturer's recommendations to avoid such issues.
On a 1988 Mitsubishi Mighty Max 2.0, the timing marks are located on the crankshaft pulley and the timing cover. The crankshaft pulley typically has a notch or a mark that aligns with the timing scale on the timing cover. Additionally, the camshaft may have a mark that needs to align with a corresponding mark on the cylinder head or cover. It's important to ensure the engine is at top dead center (TDC) on the compression stroke for proper timing alignment.
The 1988 Mitsubishi Mighty Max typically features a timing belt that should be replaced every 60,000 miles to maintain optimal engine performance. The timing specifications include a timing adjustment of 0 degrees TDC for the 2.0L engine. It's essential to ensure that the timing marks align correctly during installation to prevent engine damage. Always refer to the owner's manual or a repair guide for specific details related to your vehicle.
If the oil light comes on but the oil level is ok, the problem may be a faulty sending unit, as it turned out in my case.
yes it is
The 1988 Mitsubishi 2.0 liter engine timing marks can be found on the front main pulley. The timing marks will be scattered around the outside of the pulley.
1432
if its carbuetated then its on the motor cause its mechanical
The 1988 Mitsubishi pickup truck data link connector is located on the bottom of the drivers side dashboard. The gauge link connector will be to the left of the steering column.
one